Jeep Comanche Questions Any type
Starts runs at ideal but bogs down when you try to accelerate?
When I start my jeep the oil pressure gauge shoots past 80psi and stays there. When I shut the jeep off goes to 0. It doesn't slowly move to 80psi it just goes straight past 80psi as soon as it is ...
Drives but kinda loud and ruff. Then stalls sometimes either when I let off gas for to long or just startup but when I put gas it stays on.
I have a 1986 Jeep Comanche two wheel drive manual 4 speed 2.5 l four cylinder and I need to know if I could reach an excess of 50 miles an hour in 548 ft
My 1986 Jeep Camanche X 2.5L 4 cylinder truck Idles fine and starts fine, but as soon as it warms up it starts running bad. When I put the vehicle in Neutral And rev the engine it acts like it has no ...
Does not always start. When it does start it runs good and no other issues.
I'm trying to find replacement front fender flares for my 86 Jeep Comanche. Are there flares from other make/models of vehicles which would fit?
why cant I get the 4wd shifter to shift into either 4 h or low
I have a 89 Jeep Comanche and I want to change the steering column to a tilt column. What columns will swap. I need tilt with automatic shift on the column not floor shift.
My 87 Comanche will start up no problem but when it come to get in motion, it's a different story. It's a 4 speed manual and it will go into every gear like normal, yet no power dispersion. I'll e...
Tried to wire up the aux fan that was not working. in doing so i managed to now only have the lights, horn and radio when before everything but the fan was working. also was messing around trying to s...
I'm changing my seats, rug and dash over in my 89 Comanche. my question is what do I do about the vin since its mounted to the dash?
My turn signals work when head lights not on.When head lights on my left turn signal does not work , but my right turn signal does work.When turning the head light switch left turn signal acts like wh...
I have a1988 jeep camanche it stick an 4wd but it missing plenty parts in the engine. I also have a 1987 jeep camanche stick but not 4wd it need body work. Can i swap the 1988 4wd, bed, doors ext....
I recently installed a factory reman engine. Now it chirps and squeals and is tearing up my serpentine belt. Put new motor mounts in at the time. Any suggestions for checking alignment would help. Th...
Will restart after it sits for several hours but the same thing will occur after running a short while. I suspect the ECU but hate to miss on a $200 part.
I have a 1988 Comanche that I bought well used back in '07. Soon after, I had to replace the water pump and thermostat. After that, it would never get up to full temperature. Even on a 90 degree day...
Own this car?
Share your experience with others.
Search Jeep Comanche Questions
Jeep Comanche Experts
Know more, shop wiselySearch
Related Models For Sale