Dodge Power Wagon Questions Any type
- Recently Active
if i grab axle spindle with wheel bearings removed i can pull it out and push it back in by an inch . replacing bearings and bearing retainer because on both sides bearings wore into retainer for so...
Rough idle cuts out or off. Misses. Have donever timing chain.coil. Starter. Starter relay found the short in in the wire that made it not start. Ballistor. Coil spark plugs now has residue of carbo...
Our 77 dodge powerwagon has had some problems from the start. We had some issues with start and had replaced starter. Was fine for a while. Then later huh! No start replacedate checked everything e...
I need a 3/4 ton passenger drop front end for my 68 W200 power wagon. I know dodge used the same front end for a number of years. Can you tell me what years will fit my wagon? Thanks Mike
I have a 1984 dodge ram power wagon, it starts up just fine during the day but never in the morning when its chilly out. We put a new fuel pump in because it was flooding and ran fine for about a ...
I have a 1961 Dodge W200 Power wagon and it looks like the engine is seized. I would like to fine a replacement but I can't fine one. Can you help?
Converter was under warranty and changed but engine light almost immediately illuminated. What action is now required?
How many people have had trouble shutting your truck off INSTEAD of not being able to get it to start? I have a 77 W150 with 400 and upgraded to 100 amp alternator a few years back. I bypassed the am...
Does the giant hub (?) nut need to come off to get the drums off? I see some type of pin or keeper on the side of the giant nut. How do I get this off in order to get a socket onto the nut? (If I ne...
I want to build/put a motor in a 1958 power wagon and need the technical specs
Search Dodge Power Wagon Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
Dodge Power Wagon Experts