Chrysler New Yorker Questions Maintenance & Repair
- Recently Active
I am in need of a new inspection plate to cover the hole where my flywheel is at. I've searched everywhere and cant find one. Does anyone know a website or store I can get one from? I'm talking abo...
Have a 2017 Transit 250, and this headphone looking jack is under the radio.
Would the bolt patterens be the same on the transmission mounts on a 96 v6 camero vs. A 94 v8 camero with the LT1. Engine
What causes the tapping under the valve cover towards the front of the engine,the rocker arms are tight 4.0 engine
Mycar was low on gas when start then it started I got more gas in it and now it won't start it's acting like it has no fuel the alarm has been messing up as well what do I do
Why is it my 03 sonata keeping stalling after every 15 min
The heat on my driver side stopped working but the Air pressure itself is fine anything I can do ?
So murano just started to do this. When I turn the key to start it, it makes a high pitch ringing noise. And it lasts for about 30 seconds and stops.. no codes are tripped. Even tried to disconn...
Can any one tell where the wires go on this actuator, it controls the heat/cold is on buick lesebra limited with digital claiment control. the actuator has 5 pins 5,6,7,9,10 or post a wire digra...
Where are the rear gears in my 94 Jeep Cherokee sport work in my 99 Jeep Grand Cherokee Limited
I have an 04 Sport Trac and it turns on, stays good for maybe a minute, and if I don't accelerate it the motor begins to shake, the RPMs go down to about 1/2, and the truck turns off
My message box shows transmission perfomance reduced .What is the problem
how do I locate and change the knock sensor on my 2008 Chrysler town and country with 3.3 engine ?
the theft light is blinking. Does it always blink?
Will a 1986 mazda b2000 manual transmission fit and work well with a 1992 b2600i engine?
drivers power seat stopped wont move. Heated seat works
Trying to reprogram anti theft and keeps telling me out code invalid what do I need to do ?
My piston rod is bent. So I either replace or buy a whole new engine. What other kind if engine would be compatible with mine
Sometimes, few and far between, my Durango doesn't stay started. I have to restart with foot on gas pedal and drive with both feet for a few minutes. Then it's OK! The weather makes no difference. S...
I pulled off my crank position sensor wire while removing my alternator. I can't tell where it came out of. Any help would be appreciated.
Search Chrysler New Yorker Questions
Chrysler New Yorker Experts
Related Models For Sale