1992 Chrysler newyorker

Asked by Jan 15, 2019 at 10:36 AM about the 1992 Chrysler New Yorker Salon

Question type: Maintenance & Repair

Okay folks so as we know is cold as can be
outside. I recently purchased a 1992 Chrysler
newyorker in hope of reliable transportation.
It’s doing that just fine. But when I get in the
car and turn the key on when I move the air
selector switch nothing happens no heat no
ac no air coming thru the vents at all. I’ve
tested the blower motor and it works. No
fuses are blown.... help?

1 Answer


1. Check radiator coolant level. Really low coolant can prevent it from heating the core properly; a failed thermostat will act similarly. An air bubble in a heater line can block fluid passage and should be purged properly (lots of videos about this on line). 2. The ductwork has blend doors that move to get the temperature to the vent where you want it. The blend door that throttles hot/cold is sticking because the door actuator is defective. You may have noticed a tapping sound under the dash from a defective actuator. Try a spray lubricant on the actuator, or remove it to see if there's a broken sprocket. Might need replacing. It's not a difficult fix.

Your Answer:

Chrysler New Yorker Experts

  • #1
    Peter Nichols
  • #2
  • #3
    Michael Jernigan
View All

Find great deals from top-rated dealersTM


Related Models For Sale

Used Cadillac DeVille
3 Great Deals out of 875 listings starting at $2,995
Used Lincoln Town Car
12 Great Deals out of 1,098 listings starting at $1,000
Used Ford Crown Victoria
556 listings starting at $1,750

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.