2007 chrysler crossfire starts then quits. Does this two-three times then completely stops turning over. I can then remove the battery ground and reattach starting this process all over.
Asked by Butterfield Feb 11, 2014 at 07:46 PM about the 2007 Chrysler Crossfire Roadster Limited
Question type: Maintenance & Repair
2007 chrysler crossfire starts then quits. Does this two-three times then completely stops turning over. I can then remove the battery ground and reattach starting this process all over. RCM looks good upon inspection. I see mention of a screem sensor?? Where is it and can I replace it without going to a dealer?
4 Answers
thejeepdoctor answered 3 years ago
sounds like the security is shutting it down. just turn the key to run position and see if a red light stays on or flashes. If so there is a security issue. Are you using a programmed key?
Butterfield answered 3 years ago
I am using a programmed key and I did not notice any red light indicating a security issue. The battery has been tested and is good. Seems like it is not getting fuel or that something is cutting it off. After reading I some blogs I thought it might be the skreem module but not sure how to test. No check engine light showing either. Could a clogged fuel filter cause this same problem? Thanks for your previous reply..
Butterfield answered 3 years ago
Been in the shop for past two weeks keep getting various answers. Final answer is that it needs part #5102774aa power door lock actuator?? Part should be in tomorrow will see if this fixes the problem. Prior to this they were thinking RCM module and Skreem module?? not feeling really confident.
Your Answer
Related Questions
-
2007 chrysler crossfire starts then quits. Does this two-three times then completely stops turning over. I can then remove the battery ground and reattach starting this process all over. 4 answers
2007 chrysler crossfire starts then quits. Does this two-three times then completely stops turning over. I can then remove the battery ground and reattach starting this process all over. RCM looks g...
2007 Chrysler Crossfire Roadster Limited
-
Maintenance & Repair
-
Is there an answer to Butterfield question about his crossfire starting briefly and then shuts down immediately 2-3 times? My 04 does the same thing. 1 answer
04 crossfire starts and immediately stops 2-3 times then nothing. Disconnect and reconnect battery cable and it will do the same thing all over again. Any help?
2004 Chrysler Crossfire Limited
-
Maintenance & Repair
-
Crossfire won't start unless I disconnect and then reconnect battery 2 answers
I checked the solder connections on RCM, They looked good.
2007 Chrysler Crossfire Coupe
-
Maintenance & Repair
-
My 2006 Chrysler Crossfire won't start. 4 answers
The battery tested out fine and has a 98% charge, The ignition lights, interior lights and radio work, but the starter won't engage. However, when I disconnected the battery to test it and then reconn...
2006 Chrysler Crossfire Roadster
-
Maintenance & Repair
-
05 Crossfire rear window falling out. Called the Chrysler # and was told the extended warranty is VIN specific and does not cover all Crossfires. Anybody know if this is true? 2 answers
crossfire rear window
2005 Chrysler Crossfire Roadster Limited
-
Maintenance & Repair
Looking for a Used Crossfire in your area?
CarGurus has 349 nationwide Crossfire listings starting at $3,800.
Shortcuts
Search Chrysler Crossfire Questions
Chrysler Crossfire Experts
-
#1Tom DemyanReputation440
-
#2mybanezReputation380
-
#3SRQfunReputation350
Related Models For Sale
Used Cars For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.