2001 Dodge Ram only runs if I put gas down throttle body. Changed the Chrank shaft position sensor, cam shaft position sensor and ECM. 50 psi at gas rail. I'm out of ideas.any suggestions?

Asked by 1Ol30 Jun 26, 2015 at 09:25 AM about the 2001 Dodge RAM 2500 ST LB 4WD

Question type: Maintenance & Repair

2001 Dodge Ram only runs when gas is poured down throttle body. Changed crankshaft
position sensor, camshaft position sensor, coil and wires. Put in a rebuilt ECM. Checked
and found 50 psi at fuel rail. OBDII shows no codes. I am flat out of ideas, any hints.
Thanks

157,505

Bob answered 8 years ago

Check for injector pulse. Fuel pressure at the rail is great, but the injectors need to be pulsing to get the fuel into the cylinders.

Mark helpful

Your Answer:

2001 Dodge Ram only runs if I put gas down throttle body. Changed the Chrank shaft position sensor, cam shaft position sensor and ECM. 50 psi at gas rail. I'm out of ideas.any suggestions? 1 Answer

2001 Dodge Ram only runs when gas is poured down throttle body. Changed crankshaft position sensor, camshaft position sensor, coil and wires. Put in a rebuilt ECM. Checked and found 50 psi at fuel r...

2001 Dodge RAM 2500 ST LB 4WD

-

Maintenance & Repair
My 98 Dodge Ram 2500with 5.9 gas engine will run for about a minute than quit. My fuel pump is working. When it stops I check the rail pressure and there is none, however, when i take the line off the tank, there is all kinds of -pressure. Any ideas? 3 Answers

My 98 Dodge Ram 2500with 5.9 gas engine will run for about a minute than quit. My fuel pump is working. When it stops I check the rail pressure and there is none, however, when i take the line of...

1998 Dodge RAM 2500 ST LB 4WD

-

Maintenance & Repair
I have a 2006 2500 Dodge Ram diesel and I can't get out of park. Already replaced the line from the shifter to the tranny and still can't get it to change gears. someone told me there is a brake sensor that allows you to change the gears where is it located 1 Answer

my truck wont come out of park. No tranny problems before last weekend. Changed the cable from the shifter to the tranny cause I broke it and still truck can't change gears. Please help

2006 Dodge RAM 2500 SLT Quad Cab RWD

-

Maintenance & Repair
how do you replace the crank shaft sensor in a 2004 dodge 2500 1 Answer

diesel mechanic said to use 10mm socket to remove the bolt but it is to big yet the 9 and 8mm wont work either

2004 Dodge RAM 2500 SLT Quad Cab 4WD

-

Maintenance & Repair
2001 Dodge Ram 2500 4x4 5.9L gas, 6 Answers

If a tps and map were both bad or either one defective on its own, Would that cause a vehicle to not shift into gear?

2001 Dodge RAM 2500 SLT Plus Quad Cab 4WD

-

Maintenance & Repair

Own this car?

Share your experience with others.

2001 Dodge RAM 2500

Write a car review

Review another car

Used Chevrolet Silverado 2500HD

1,064 Great Deals out of 30,973 listings starting at $1,350

Used Ford F-250 Super Duty

1,435 Great Deals out of 42,920 listings starting at $2,000

Used Dodge RAM 3500

34 Great Deals out of 492 listings starting at $3,300

Used Dodge RAM 1500

85 Great Deals out of 1,594 listings starting at $995

Used GMC Sierra 2500HD

569 Great Deals out of 21,049 listings starting at $5,988

Used Ford F-150

6,203 Great Deals out of 134,344 listings starting at $900

Used Chevrolet Silverado 1500

4,124 Great Deals out of 131,322 listings starting at $1,000

Used Ford F-350 Super Duty

933 Great Deals out of 22,972 listings starting at $3,500

Used Toyota Tundra

1,134 Great Deals out of 34,017 listings starting at $3,399

Used GMC Sierra 1500

1,966 Great Deals out of 67,025 listings starting at $1,100

Used Toyota Tacoma

2,012 Great Deals out of 33,616 listings starting at $2,990

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

2001 Dodge Ram only runs if I put gas down throttle body. Changed the Chrank shaft position sensor, cam shaft position sensor and ECM. 50 psi at gas rail. I'm out of ideas.any suggestions?

1 Answer

Your Answer:

Own this car?

Share your experience with others.

Shortcuts

Search Dodge RAM 2500 Questions

CarGurus Experts

Know more, shop wisely

Related Models For Sale

Used Cars For Sale

2001 Dodge Ram only runs if I put gas down throttle body. Changed the Chrank shaft position sensor, cam shaft position sensor and ECM. 50 psi at gas rail. I'm out of ideas.any suggestions?

1 Answer

Your Answer:

Related Questions