HOW DO I INSTALL IGNITION MODULE 1987 F150 FORD TRUCK

Asked by Mar 03, 2015 at 11:58 PM about the 1984 Ford F-150

Question type: Maintenance & Repair

1 Answer

96,935

Ford had 2 locations on Trucks depending on the size, one location was on the distributor, the other was on the drivers side on the front core support and had a heat sink around it. Both were held in place by 2 5.5mm bolts, on the distributor units you removed the bolts and carefully slid the module down until it disconnected itself from the pickup coil inside the distributor, (note: if the wiring gets pulled out of the pickup coil then you will have to replace it also) then install new module and secure. On the core mounted one just unbolt it remove the bad module and replace it with the new one. Just don't forget in special silicone grease supplied with the new modules, it is the heat transfer paste for the modules. HTH

Your Answer

Add photo

Related Questions

Search Ford F-150 Questions

Ford F-150 Experts

#1 OJ
OJ
Reputation 8,490
#2 dandyoun
dandyoun
Reputation 4,420
#3 tennisshoes
tennisshoes
Reputation 2,950
View All

Related Models For Sale

Used Ford F-250
457 listings starting at $4,390
Used Ford Mustang
700 Great Deals out of 44,788 listings starting at $1,500
Used Ford Ranger
173 Great Deals out of 5,596 listings starting at $900

Used Cars For Sale

2018 Ford F-150 For Sale
862 listings starting at $29,070
2017 Ford F-150 For Sale
67 Great Deals out of 124,330 listings starting at $18,199
2016 Ford F-150 For Sale
119 Great Deals out of 9,501 listings starting at $14,950
2015 Ford F-150 For Sale
215 Great Deals out of 8,901 listings starting at $15,990
2014 Ford F-150 For Sale
346 Great Deals out of 12,528 listings starting at $9,900

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.