i have a 1988 for bronco 2 it has a brand new shift motor 4 wheel drive i changed the module and the 4 wheel light comes on because its in 4 wheel drive but it wont shift at all is there any thing els

30

Asked by Dec 03, 2013 at 07:26 PM about the 1988 Ford Bronco II XLT 4WD

Question type: General

1 Answer

97,225

Is the transfer case in good shape? Did you make sure the shift motor was in the correct position to match the transfercase location ie 4 Hi or 4Lo or neutral? Have you tried removing the shift motor and grounding it with all of the wiring hooked up try to make it run by activating the 4X4?

1 of 1 people found this helpful.

Your Answer

Add photo

Related Questions

Search Ford Bronco II Questions

Ford Bronco II Experts

#1 tennisshoes
tennisshoes
Reputation 590
#2 Andrew Olsen
Andrew Olsen
Reputation 230
#3 Colin Rivet
Colin Rivet
Reputation 220
View All

Related Models For Sale

Used Ford Bronco
196 listings
Used Ford F-150
2,129 Great Deals out of 191,043 listings starting at $290
Used Ford Ranger
183 Great Deals out of 5,624 listings starting at $900
Used Jeep Wrangler
297 Great Deals out of 15,879 listings starting at $3,495
Used Ford Mustang
724 Great Deals out of 44,318 listings starting at $1,500
Used Chevrolet Blazer
3 Great Deals out of 1,182 listings starting at $1,495
Used Jeep Cherokee
366 Great Deals out of 40,280 listings starting at $1,500
Used Chevrolet Camaro
367 Great Deals out of 31,402 listings starting at $2,400
Used Toyota Land Cruiser
9 Great Deals out of 1,031 listings starting at $3,700

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.