I have a 1986 Bronco II. I have replaced starter twice in the last six months. A year ago I had the clutch, flywheel and bearing replaced. It makes a awful loud noise when I start it. Puzzled!

I have a 1986 Bronco II. I have replaced starter twice in the last six months. A year ago I had the clutch, flywheel and bearing replaced. It makes a awful loud noise when I start it. Puzzled! 1 Answer

I have a 1985 Bronco II standard shift, I need to change the ECM. where is it located? 1 Answer

I am trying to change out the Engine Control Module (ECM) where will I find it?

I have a 88 Bronco II that won't start 5 Answers

I have replaced a starter (burned-up) , start solenoid (old one stuck on), start switch.....after all this ....solenoid gets stuck on ....stays on after switch is turned off, even after ignition wire ...

i have a 1986 bronco 2 when i try to start it it will run until i release it from the start position then its like you turned the key off. Not sure if its a relay or in the start switch, 2 Answers

I have fuel pressure and i have spark when im starting the truck. It cranks up then dies as soon as i let from the start position. Where do i begin

I have a bronco 2 aoutmatic and I been having a problem going forward. I put some transmission fluid in and when I put it in drive, the gear doesn't work? Anyone know why? 6 Answers

I have to touch the gas for a little bit ll I feel it go into drive