I have a 88 Bronco II that won't start

Asked by Oct 04, 2014 at 06:11 PM about the 1988 Ford Bronco II Eddie Bauer 4WD

Question type: Maintenance & Repair

I have replaced a starter (burned-up) , start solenoid (old one stuck on), start switch.....after all this ....solenoid gets stuck on ....stays on after switch is turned off, even after ignition wire on solenoid is pulled off. won't start engine....any idea???

5 Answers


Get it fixed. It probably needs some repairs done.


Bad igintion switch.

1 of 1 people found this helpful.

T_S_T , I have already replaced that....now what?


Recheck the starter wires, at cylinoid,and make sure they are not crossed.

1 of 1 people found this helpful.
Best Answer Mark helpful

No crossed wires made sure of that, found rusted relay , replaced and it started up.....going to give it a test drive and see if that was the problem.

Your Answer

Bronco II

Looking for a Used Bronco II in your area?

CarGurus has 17 nationwide Bronco II listings and the tools to find you a great deal.


Ford Bronco II Experts

  • #1
  • #2
    Andrew Olsen
  • #3
    Colin Rivet
View All

Related Models For Sale

Used Ford Bronco
207 listings
Used Ford F-150
3,333 Great Deals out of 221,765 listings starting at $1,200
Used Ford Ranger
196 Great Deals out of 5,547 listings starting at $999
Used Jeep Wrangler
504 Great Deals out of 19,435 listings starting at $2,500
Used Ford Mustang
606 Great Deals out of 39,402 listings starting at $1,895
Used Jeep Cherokee
525 Great Deals out of 61,356 listings starting at $3,995
Used Chevrolet Blazer
6 Great Deals out of 931 listings starting at $950

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.