Was driving down the highway, my horn started blaring. Did not stop until it died. It did a fading out die not an abrupt
3 Answers
Rebecca answered 2 years ago
Thank you. So replace the horn switch in the steering wheel?
T_S_T answered 2 years ago
Yes,but it may have damaged the horn all so,try replacing horn switch,the you may have to replace horn,but before you start any of this,allways check the fuse,s.
Your Answer
Related Questions
-
Was driving down the highway, my horn started blaring. Did not stop until it died. It did a fading out die not an abrupt 3 answers
2007 Ford Mustang V6 Deluxe
-
Maintenance & Repair
-
What is the cause for my GT to die upon start up after it sits a day or so? 4 answers
I own a 2000 GT and now after it sits for longer than a day it doesn't want to idle properly upon start up. If i keep my foot on the gas pedal it will keep running and finally idle just fine. No issue...
2000 Ford Mustang GT
-
Maintenance & Repair
-
i have a 1996 3.8 232 for mustang i was driveing down the road when alot of white smoke and anti frezze came pouring out my exhaust and anti frezze check engine light started flashing and it was not r 12 answers
what could it be
1996 Ford Mustang STD Coupe
-
Maintenance & Repair
-
I have a1995 ford mustang GT 5.0. recently I was reving my engine, and just shortly after my car started bucking and hesitating. Almost dieing at a complete stop. If the stop was long enogh it would stop. I have changed the EGR valve, the IAC valve and the fuel regulator. Also I have replaced all of the hoses that go to the upper intake and the upper intake gasket. I just cleaned the MAF sensor with MAF sensor spray cleaner and now the the check enging light is on and it hesitates when I drive. but the rpms are steady as to where before they were all over the band. any Ideas 4 answers
I have a1995 ford mustang GT 5.0. recently I was reving my engine, and just shortly after my car started bucking and hesitating. Almost dieing at a complete stop. If the stop was long enogh it would...
1994 Ford Mustang GT Coupe
-
Maintenance & Repair
-
My 90 GT Conv't has an idle problem. Only when it ain't been cranked up in a while. I have to crank it up and immediately hit the gas pedal or it will die. Is it the idle control sensor? 17 answers
I think it has a cam in it, but it started doing this about 3-4 months ago. I have had the car since Feb but had no problem with it.
1990 Ford Mustang GT Convertible
-
Maintenance & Repair
Looking for a Used Mustang in your area?
CarGurus has 44,705 nationwide Mustang listings starting at $1,500.
Shortcuts
Search Ford Mustang Questions
Ford Mustang Experts
| #1 |
|
Tom Demyan
Reputation
4,500
|
| #2 |
|
Bob Beaman
Reputation
1,240
|
| #3 |
|
COMETGUY61
Reputation
1,090
|
Related Models For Sale
Used Cars For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.