I have 2.2 S-10 motor but I have fuse block for 4.3 vortex v6 should they be compatible is there a certain way I map relays and fuses to make work reason I believe it should is because they are ident.

Asked by James Nov 07, 2015 at 05:58 PM about the 1998 Chevrolet S-10 LS Extended Cab RWD

Question type: Maintenance & Repair

I really need to know the trick to breaking
down fuse block

220,955

Rowefast answered 8 years ago

I am not sure what you are asking, is this thing running? Long as the plugins fit there designated sensors, as long as the fuse box is a factory install, leave it alone. If nothing is matching up because of motor swap, then you need to replace the wiring, fuse box, & the OBD1 pcm.

Mark helpful

Your Answer:

I have 2.2 S-10 motor but I have fuse block for 4.3 vortex v6 should they be compatible is there a certain way I map relays and fuses to make work reason I believe it should is because they are ident. 1 Answer

I really need to know the trick to breaking down fuse block

1998 Chevrolet S-10 LS Extended Cab RWD

-

Maintenance & Repair
I have a 1998 s 10 extended cab pick up truck 2.2 automatic transmission 4L60E my question is would a trani of a v6 vortec md8 work. And fit for my truck 1 Answer

Im trying to put an automatic transmission of v6 s10 md8. Serial 8676339 to a 98 s10 pick up truck 2.2 and it has a 4L60E serial 24207965 will it fit and. Work for my 2.2 s10 truck ?

1998 Chevrolet S-10 LS Extended Cab RWD

-

Maintenance & Repair
hello i have a 91 s10 with the 4.3 v6 the truck ran great with a broken motor mount on the driver side but after replacing it the truck wont start motor is getting gas fire and air PLEASE HELP 2 Answers

4.3 v6 with 3k+ miles ran great did full tune up still ran great then i replaced the driver side motor mount and it wouldn't start i used a jack to lift the motor to replace the broken mount im gett...

1991 Chevrolet S-10

-

Maintenance & Repair
why is my 1998 S-10 2.2 auto bog down very bad when I try to punch the gas. I just install a very good battery and have one on those innova 3100 abs models and it read that ther are no stored data or 3 Answers

my S-10 will bog down when I try and punch the gas. My inniva scanner says no stored data or freeze frame data either. It was running fine and then when my wife was coming home from work it started up...

1998 Chevrolet S-10 LS RWD

-

Maintenance & Repair
I have a 89 S-10 4.3 and it backfires through throttle body 2 Answers

89 S-10 backfires through throttle body lack of power at acceleration and service engine light comes on after a while I've checked timing plugs and wires and did a diagnostic test and it showed not...

1989 Chevrolet S-10 RWD

-

Maintenance & Repair

Own this car?

Share your experience with others.

1998 Chevrolet S-10

Write a car review

Review another car

Used Chevrolet Silverado 1500

4,102 Great Deals out of 131,112 listings starting at $1,000

Used Ford Ranger

561 Great Deals out of 11,196 listings starting at $800

Used Toyota Tacoma

1,909 Great Deals out of 31,213 listings starting at $3,500

Used GMC Sonoma

49 listings starting at $6,995

Used Ford F-150

6,057 Great Deals out of 129,349 listings starting at $1,100

Used GMC Sierra 1500

1,835 Great Deals out of 65,440 listings starting at $3,400

Used Dodge Dakota

22 Great Deals out of 484 listings starting at $2,400

Used Nissan Frontier

726 Great Deals out of 22,766 listings starting at $1,750

Used Chevrolet Camaro

585 Great Deals out of 9,399 listings starting at $2,000

Used Chevrolet C/K 1500

243 listings starting at $7,960

Used Chevrolet Blazer

694 Great Deals out of 15,340 listings starting at $14,988

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I have 2.2 S-10 motor but I have fuse block for 4.3 vortex v6 should they be compatible is there a certain way I map relays and fuses to make work reason I believe it should is because they are ident.

1 Answer

Your Answer:

Own this car?

Share your experience with others.

Shortcuts

Search Chevrolet S-10 Questions

CarGurus Experts

Know more, shop wisely

Related Models For Sale

Used Cars For Sale

I have 2.2 S-10 motor but I have fuse block for 4.3 vortex v6 should they be compatible is there a certain way I map relays and fuses to make work reason I believe it should is because they are ident.

1 Answer

Your Answer:

Related Questions