Chevrolet S-10 Questions Any type

  • Newest
  • Recently Active
  • Unanswered
John Asbury
0

Lose All Power To Inside When Turning Key To Start

I changed engine on 98 s10 and put a 1995 engine in it out of a s10 blazer. Changed all of the wiring harnesses inside and out. Even used the s10 Blazer computer but when I turn the key on I have noth...

7 views with 1 answer (last answer 11 hours ago)
Jodyjody
0

5 Speed Transmission 1991 Chevy S10

Got truck no clutch took tranny out clutch, pressure plate new pressureplate only had 3bolts2waser replaced all new,also replace bearings, pilot throwout,new master an slave cyl,removed all air o...

5 views with 1 answer (last answer about a day ago)
Beth_kennard
0

Truck Dying

I have a. 2000 s10 2.2 standard truck.about 6 months ago it died while I was driving for the first time.happened sporadically and I noticed that if I was under a half of tank of gas or if it was ...

5 views with 3 answers (last answer 2 days ago)
vitimamR
0

2000 S10 4.3 Overheating

My truck is over heating I have flushed the system three or four times changed water pump thermostat did a Chen wash and rinse changed temp sensor but it still wants to overheat but it doesn't over...

Stonecrab007
0

These Fell Off My 2001 S10 Near Front Passenger Tire. I Drove 6-8 Miles Whe...

Tires Plus thought they were front end alignment shims. Local chevy dealer service dept. had no clue

Trebor66
1,445

Drive Train Issue.

What would the symptoms of a failing torque converter be. When cold from sitting over knight. When drive is selected after backing out of driveway it sometime "jerks" or stutters when forward movement...

Caleb Duchene
0

Non-start

My truck has compression. it has spark. It has fuel in the rail but no getting injected into any cylinder.

maddnnes
0

What O2 Sensor Should I Change ?????

I went and got a e-test today and failed. I was woundering if anyone can make sence of it : Under Systems Monitored it says Misfire (Ready) Fuel system (Ready) Comprehensive Components (Ready) Catalys...

11 views with 2 answers (last answer 6 days ago)
Bubbaray1949
0

2001 S10 Starting Problem

My 2001s10 will not start in less you hold it to the floor and let it turn over tell it starts and then it won't stay running long put new fuel injectors in it new plugs new wires new crank shaft s...

8 views with 2 answers (last answer about a week ago)
Brooke Arkless Avila
0

Wontvstart

My fiance s10 won't start for a while he it theclutch , what caused that?

0 views with 1 answer (last answer about a week ago)
maddnnes
0

O2 Sensors On A 1999 Chev S10

location of the o2 sensors

13 views with 1 answer (last answer about a week ago)
Gman90210
0

1999 Chevy S10

Hey guys what years of an chevy s10 gas tank will fit my 1999 s10

Trebor66
1,445

Pittman Arm Replacment

2000 model S-10 V 6. Is it possible to replace the Pittman arm using a puller without removing the gear box from the truck. If so are there any specifics that need to be known before it's removal.

17 views with 4 answers (last answer 6 days ago)
Roamingd
0

1st Gen S10 Extended Cab Seat Relocation

Hi and thanks in advance for any and all advice. I just purchased my first s10. Its a 93 extended cab with a 5 speed. My problem is that i sit too close to the wheel and its even difficult to push ...

oldtree
0

'03 S-10 Blowing Off Fuel Line

Why does my '03 4.3L 5spd 4x4 S-10 blow the fuel line off at the front of the in-line filter? Connector and clip look good and feel secure until I try to start it; then it blows off.

5 views with 1 answer (last answer about a week ago)
strkndrfwd
0

Have A 2003 S10 , 4.3l, 4 Wheel Drive, Trying To Remove Starter, How?

How do I get the starter out, not enough room to drop it down. Do I need to remove anything else?

6 views with 1 answer (last answer about a week ago)
Smokey1982
0

S10 Rod Bearings

Can u get an oversized rod bearing for a 4.3 in a 97 S104x4

5 views with 1 answer (last answer about a week ago)
Gstoner90
0

Brake And Driver Side Turn Lights Don't Work And Keeps Blowing Fuses

1991 s10 4.3 4x4 drivers side turn light and brake lights aren't working and now it's blowing the turn signal fuse

7 views with 3 answers (last answer about a week ago)
Truckjew
0

99s10 With O1 Blazer Motor

Truck loosing pressure @50mph loosing all powers then bogges out and dies the gass peddle doesn't seem right and just won't turn over 4.3 vortec

1 2 3 4 5 ... 66 next

Favorite this topic

Subscribe to Chevrolet S-10 questions.

Search Chevrolet S-10 Questions

Chevrolet S-10 Experts

#1 Andrew Olsen
Andrew Olsen
Reputation 1,960
#2 John Saffrahn
John Saffrahn
Reputation 880
#3 Trebor66
Trebor66
Reputation 830
View All

Related Models For Sale

Used Ford Ranger"
248 Great Deals out of 7,741 listings starting at $988
Used Chevrolet Silverado 1500"
2,171 Great Deals out of 135,552 listings starting at $1,500
Used Chevrolet Colorado"
327 Great Deals out of 17,737 listings starting at $2,495
Used GMC Sonoma"
13 Great Deals out of 611 listings starting at $1,500
Used Toyota Tacoma"
574 Great Deals out of 27,611 listings starting at $2,199
Used Dodge Dakota"
146 Great Deals out of 4,816 listings starting at $1,250
Used Ford F-150"
2,811 Great Deals out of 204,923 listings starting at $1,500
Used Chevrolet Blazer"
4 Great Deals out of 1,643 listings starting at $1,995
Used Nissan Frontier"
398 Great Deals out of 20,727 listings starting at $1,795
Used GMC Sierra 1500"
897 Great Deals out of 53,143 listings starting at $2,400
Used Dodge Ram 1500"
530 Great Deals out of 13,714 listings starting at $1,195
Used GMC Canyon"
111 Great Deals out of 7,918 listings starting at $1,500
Used Chevrolet C/K 1500"
1,180 listings starting at $1,895
Used Toyota Pickup"
123 listings starting at $4,500
Used Ford Mustang"
757 Great Deals out of 40,110 listings starting at $1,450