I have a 1993 ford ranger xlt with a 3.0 v6 looking for an all-metal concentric clutch slave cylinder. I have been to too many auto parts sites and all offer plastic slave cylinders. Where to find?

I have a 1993 ford ranger xlt with a 3.0 v6 looking for an all-metal concentric clutch slave cylinder. I have been to too many auto parts sites and all offer plastic slave cylinders. Where to find? 1 Answer

on a 1997 ford ranger 4.0 enging 5 speed manull transmisions i put new cluth presure plate and slave cylinder and resavore still cant get a clutch pedal to ingage the p plate and also bleed it 1 Answer

still want press p plate is there a diffrents in internal slave cylinder between one for 4 cylinder and v6

I have a 96 Ford Ranger which will not shift. Replaced the clutch, slave and master and grease Eric 3 Answers

several garages have looked at it. Need to figure out if it is the transmission or not? 280K miles on it. Thanks

I have a 1993 Ford ranger 1 Answer

1993 Ford ranger got from friend check engine light was on, it stalled at stops restarted rite away then the starter went ,got new one now when I drive it won't restart only when it wants to that ...

I have a 96 Ford ranger, 4 cylinder manual and have a problem I can't figure out. I can start the truck every time with no problem it isles great and I can sit there and rev it all day no problem but if I go to drive it I can make it about 1/2 mile and then that's it, ill press the gas petal and it won't do any thing but kill the gas (no gas) but soon as I take my foot off the gas it will idle just fine and rev fine but won't go anywhere unless I let it sit for a few mins and it will start all over. I have replaced the IAC, TPS and today the external fuel filter that was clogged but same thing. Once in a while if I push the clutch in it will stay at a rev for a sec. Please help 5 Answers

96 Ford ranger need help :(