intake air temp sensor wires are clipped i dont know the color of the wires that goes to it
1 Answer
dvigano answered 9 years ago
Hi cool1latino, Try looking for the brown and green/black wires that are plumbed either to the connector or directly to the sensor. Good luck!
Your Answer
Related Questions
-
intake air temp sensor wires are clipped i dont know the color of the wires that goes to it 1 answer
i need to know the color of the 2 wires to the intake air temp sensor there clipped can you tell me the color of the wires so i can trace them?
1989 Ford Mustang
-
Maintenance & Repair
-
Does anyone know how to work the air controls on a 1966 mustang? I'm sure this is a standard Ford part.I'm not even sure what they're called, fan / air conditioning / force blown air, etc.. My 1966 mustang came with A/C standard. In the dash there are chrome controls for the air. One lever is horizontal and has about 5 notches that it clicks into place. It slides from left to right and back. Have no idea what that does. Directly underneath are three vertical levers.. The first one is labeled HEAT. I can't figure out if it being in the up position is turning the heat on or off. Next to that is TEMP. Next to that is a blank one. All three slide up and down. Does anyone have any idea how these work? I'm trying to get the heat to work and am freezing my a** off, as it seems to be blowing A/C. 5 answers
Air controls for 1966 Ford Mustang with A/C.
1966 Ford Mustang Base
-
Maintenance & Repair
-
I have a1995 ford mustang GT 5.0. recently I was reving my engine, and just shortly after my car started bucking and hesitating. Almost dieing at a complete stop. If the stop was long enogh it would stop. I have changed the EGR valve, the IAC valve and the fuel regulator. Also I have replaced all of the hoses that go to the upper intake and the upper intake gasket. I just cleaned the MAF sensor with MAF sensor spray cleaner and now the the check enging light is on and it hesitates when I drive. but the rpms are steady as to where before they were all over the band. any Ideas 4 answers
I have a1995 ford mustang GT 5.0. recently I was reving my engine, and just shortly after my car started bucking and hesitating. Almost dieing at a complete stop. If the stop was long enogh it would...
1994 Ford Mustang GT Coupe
-
Maintenance & Repair
-
lost the anti theft chip that goes under the dash of my 2001 ford mustang. How do I get it to start? 2 answers
I have a 2001 Ford Mustang convertible. It has the ANTI-THEFT chip device that goes in your key AND IS ALSO located in my steering colum underneath the dashboard. How can I start my car without having...
2001 Ford Mustang Cobra
-
Maintenance & Repair
-
I have a metal tube similar to the fuel tube from the fuel pump in a 76 cobra 302 that I took out and now do not know where it goes...can somebody help? 1 answer
This tube is very long and looks like it needs to hook up somewhere under the car and runs int the engine compartment. Mdcrist@yahoo.com
1976 Ford Mustang Cobra II
-
Maintenance & Repair
Shortcuts
Search Ford Mustang Questions
Ford Mustang Experts
| #1 |
|
Tom Demyan
Reputation
4,500
|
| #2 |
|
Bob Beaman
Reputation
1,240
|
| #3 |
|
COMETGUY61
Reputation
1,090
|
Related Models For Sale
Used Cars For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.