Do I have to remove the entire dashboard to replace the blower motor in a 2011 Nissan sentra
STOP the Presses!....NO U dont! This is my post from another Question on here: http://www.cargurus.com/Cars/Discussion-t32194_ds570374? sntEmlId=356967536#msg498779 my research for 07-12 blower replacement is easy :) found this on a Nissan forum. dash removal NOT needed. Removal from lower drivers side foot area. drivers seat removal May be helpful (for more room)...but not needed. a few pointers: battery disconnection recommneded. i did not remove the drivers seat, as i had enough room to maneuver around. Pedal assembly removal....Remove the 4 nuts and 3 connectors and the pin attachemnet to master-cylinder push rod....for the pedal assembly to be removed. my 08 had a black box in the way....w 3 connectors. i disconnected them and removed the box....as it was going to be rt in my way. i also removed its aluminum mnt bracket after removing the 1 screw attaching it. i then had to remove the heater Mode motor (had 2 phillips screws retaining it). remove motor elec connector and 1 screw retaining motor. release tab above the retainer screw if needed, and rotate motor COUNTERclockwise. my 1st blower replacement...and not a bad job. id say it took me 2 hrs at most....but may only tk an hr or so if i had to do it again. HTH, Marti also, found a 4 Seasons blower motor on Ebay w free shipping for $106. no one else had it in stock or cld even get it. tore apart the original motor....had worn out brushes. no speed controller/resistor was needed for my repairs....jst the motor
Search Nissan Sentra Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
Nissan Sentra Experts