vabration and 1st gear problems

Asked by May 08, 2017 at 03:48 AM about the 2003 Chrysler Neon

Question type: Maintenance & Repair

already replaced engine mountings top, middle, ect. control arms replaced cambelt and v-belt replaces.  1st gear shatter a lot  on pul away, Car still vibrating.

1 Answer

100,235

I had one that did the same thing, had to loosen all the mounts and really shake the engine and tranny around to get the new mounts to settle in then retighten them all back up and the problem went away. Then there was a car that I had to slot the bolt holes to apply some pressure on the mount to keep it from an engine shake on take off, later found out the car had been wrecked and wasn't repaired properly. HTH

Your Answer

Chrysler Neon Experts

  • #1
    Chad Prestridge
    Reputation
    90
  • #2
    Justin Gilmore
    Reputation
    80
  • #3
    Mike Bonnell
    Reputation
    60
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.