Mitsubishi 3000GT Questions Maintenance & Repair
1993 Mitsubishi - Won't Start- Key Problem
My 3000GT SL won't start. Guages, lights - everything else works. For months, if you turned the key just right, it would start. Well, it finally started for the last time. No clicking or any other...
Something Is Wrong With My Front End
i have loud squeak but the pads seem to be fine. also sounds like something is lose. the tire has no movement side to side or up and down. but i i jacked it up it did seem like the shock came way o...
Coil Problem
car runs good for 1 hour after put new coil in then coil breaks.
I Have A 92 3000gt And I'm Not Getting Fuel Or Spark Please Help Brand New ...
New battery and alternator and timing belt and water pump
How Often Do You Need To Change The Out Put Shaft On The 1995 Mitsubishi 30...
I have to replace the out put seal on the left side of my Mitsubishi 3000gt, is there an alternative more long lasting solution like a bearing that is the same size as the seal?
My Miisubihi Gt3000vr4 Twinturbo Lost Spark To One Coil Than The Other Only...
92 3000gtvr4 twin turbo lost fire to one coil wile in the parking lot one day came home and lost one more replaced the coil was not it could it be the timing belt? any one know about this ?
I Have A 1994 Mitsubishi 3000 Gt 5speed And Was Told The Ecm And Starter Ar...
I bought a 1994 Mitsubishi 3000 gt 5 speed that doesnt run. Was told it needs ecm and starter or could be a ground wire problem. How do I check to see if it's ecm and how would I replace it?
I Am Confused,
I was told that I need a belt tensioner changed when a water pump is been replaced on a 1993 Mitsubishi 3000 GT VR4, but Auto Zone said it does not need it, who is right here???
I Am Confused,
I was told that I need a belt tensioner changed when a water pump is been replaced on a 1993 Mitsubishi 3000 GT VR4, but Auto Zone said it does not need it, who is right here???
Replaced Valve Seals Now Engine Wont Start What Should I Check?
checked timing and compression left head 120psi right head 150 psi will not start.
What Other Type Of Engines Can Be Swap On A 1993 Mitsubishi 3000 Gt?
The bearings of the original engine went out tranny is good 5 speed Manual need urgent answers please. Thanx
Not Able To Start A 1999 Mitsubishi 3000 GT/SL Which Has Been Rebuild
The engine cranks but does not start. Changed CAM Sensor, CRANK Sensor, IGNITION Module and no start. Help, JDF
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.