Ford Bantam Questions Maintenance & Repair

Ford Bantum

I have a Ford Bantum Rocam 1.3 it’s doesn’t want to rev but ones I remove the plug for the map sensor it revs and black smoke coming from the exhaust please help what’s wrong with my car

Leaking Fuel , Water And Bakkoe Is Overheating. Ford Rocam 1.6

Hi we just replaced the head gasket on bakkie , but now there seem to be a whole lot of trouble with it . After the gasket were replaced they started the bakkie it started but oil leaking from the ...

Ford Bantum 1.3l Not Firing

hi all i have just swoped engines on my bantam but cant seem to get it started. the motor swings and i have spark but still not firing. i have noticed the anti theft light at the clock is permanentl...

Engine

My Ford bantam 2007 1.3 rocam has a problem of engine sound the plugs are not all firing and when I check them they are wet with oil. What may be the issue

Ford Bantam 2010 1.3 Rocam

my ford bantam cuts as if its a petrol but still start and moves but it cuts at some point

Noise In Engine

when I accelerate in any gear too hard, I get a kluging sound, until I relax on pedal. Change CV's both sides. still have problem. Sound seems to come from where left drive shaft goes into gearbox/...

Enquirer

Hi im looking for a place to get new bantam spares, most scrap yards sell me stuff without guarantee ,and they are expensive and unreasonable

Repair

I have a ford bantam rocam doesn't start when it starts it has no pulling power sorry my english not so good

Hi Guys I Have A Ford Bantam Rocam 1.3 It Over Fueling Its Starts Nice And ...

How To Adjust Handbrake

Gauges Slow To Move

Good day, Ford Bantam 1.3 Rocam 2006.....when I start my bakkie, or put in petrol, all the gauges takes a few seconds (sometimes longer) before it starts to register and for the fuel needle to go up...

Indicate Lights

Indicate lights are on and off on my ford bantam 2010 TDCI. What may be the reason?

Ford Bantam Engine Cranking But Not Sparking And Starter Not Turning Please...

hi i have got ford bantam 1.3 2006 cranking but not sparking and stater not turning, but when touching with wire does turn fuel pump working ,please assist how to sort the problem

Inner Cv

I bought a new complete drive shaft of my bantam roacam, it's still noise on the inner cv. I went to 4 mechanics. No one get it right. My car is a Roacam 2005. My email :mkgarimetsa2005@yahoo.com

Clutch Too Hard

Hi Unclear, I have put a new master clutch cylinder, slave cylinder,clutch kit. Clutch is too hard and inside are engaging but the car is not taking them. Ford bantam rocam engine 1.6 whatcould be...

Fuel With Water

Water mix with patrol

Missfire

Good day 2002 Ford Bantam 1300 Rocam I have changed coil pack, plugs, TP censor and still it missfire 2500 and 4500 RPM what can I do or charge to fix it

Overheating

Hi my 1.3 ford bantam is getting hot,no water leaks. change thermostat and waterpump,no water in oil mixing everything looks ok. Motor is running good just getting hot. Is it head gasket and do i ...

Crankin/scratching Noise When Reversing

Hi I have a 2006 Ford bantam rocam, there is terrible noise happening when the car is reversing & apply brakes it crank like 2 metal or rusted irons scrach each other it comes from front left side t...

Wipers