Mazda 2001 626 2.0

Asked by Oct 18, 2016 at 01:35 PM about the 2001 Mazda 626 ES

Question type: Maintenance & Repair

I have a 2001 Mazda 626, 20 liter engine. I change the spark plug and wires on the car. it starts, but when the car is put into drive, it cut off. It will also start in (N) to, but will cut off when shifted into drive. I change the ignition coil and redid the plugs and wires, the same thing happen. What Is wrong?

1 Answer

122,655

It could be IAC valve. does the RPM's it fluctuate ? if so then you might have a vacuum leak. Check hoses and manifold gasket. It should remain constant @ approximately 700 - 750 rpms when warmed up. Or you may want to look at your throttle clean it real good with a throttle body cleaner. While you are there check the fuel pressure

1 people found this helpful.

Your Answer:

Mazda 626 Experts

  • #1
    littlehorn
    Reputation
    430
  • #2
    tennisshoes
    Reputation
    210
  • #2
    Tom Demyan
    Reputation
    210
View All

Related Models For Sale

Used Mazda B-Series
6 Great Deals out of 207 listings starting at $1,995
Used Honda Accord
682 Great Deals out of 101,645 listings starting at $999
Used Honda Civic
486 Great Deals out of 44,345 listings starting at $1,150
Used Mazda MX-5 Miata
45 Great Deals out of 4,359 listings starting at $1,750
Used Nissan Altima
861 Great Deals out of 61,735 listings starting at $1,000

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.