I have a 1983 Chrysler Lebaron. Just changed the master cyl, front rubber hoses, brake booster, bench bled the master and all wheels and still don't have any pedal, goes to floor. only a small amount of fluid comes out when bleeding. HELP PLEASE

I have a 1983 Chrysler Lebaron. Just changed the master cyl, front rubber hoses, brake booster, bench bled the master and all wheels and still don't have any pedal, goes to floor. only a small amount of fluid comes out when bleeding. HELP PLEASE 1 Answer

No brake pedal on a 1983 Lebaron 2 Answers

Replaced the Master cylinder, brake booster, both front rubber brake hoses and pass side front caliper. Bench bled the new master b4 installing. Tried to bleed the system starting with pass rear-dr re...

I have a 1986 Chrysler Lebaron turbo which goes to bucking.. 1 Answer

I have a 1986 Chrysler Lebaron turbo which when the engine gets warmed up it start bucking like its missing or losing power. I have replaced the plug and coil. No change runs great tell it gets warmes...

91 Chrysler Lebaron Please Help!!! 4 Answers

I have a 91 Chrysler Lebaron in limp mode. I have changed the transmission,Speed sensors are all new/replaced. Could use some help please.

Why does the amp gauge go to zero, the dash lights goes out and it stalls when I'm low on break fluid and the peddle goes to the floor? 1 Answer

I have a 1984 Lebaron convertible Mark Cross edition. When the break peddle goes to the floor the car stalls. It has fluid and It may need bleeding but the confusing part is that the amp gauge goes...