how do you get the clutch rod out of a ford bronco 2

10

Asked by Mar 11, 2013 at 10:45 PM about the 1989 Ford Bronco II XLT 4WD

Question type: Maintenance & Repair

2 Answers

101,925

I assume that you mean the one in the clutch master cylinder, it is held in place by a metal clip on the end of the rod. If there is a lot of dirt or corrosion inside the bore it will be very difficult to remove, might try soaking it in a good penetrating oil overnight and try to remove it then.

1 of 1 people found this helpful.
10

yeah it has a clutch saftey switch on it need to get the clutch rod out to replace clutch saftey switch it has a 6 prong electrical plug connected to it

1 of 1 people found this helpful.

Your Answer

Ford Bronco II Experts

  • #1
    tennisshoes
    Reputation
    610
  • #2
    Andrew Olsen
    Reputation
    230
  • #3
    Colin Rivet
    Reputation
    220
View All

Related Models For Sale

Used Ford Bronco
210 listings
Used Ford F-150
2,488 Great Deals out of 193,509 listings starting at $799
Used Ford Ranger
156 Great Deals out of 5,417 listings starting at $800
Used Jeep Wrangler
322 Great Deals out of 17,048 listings starting at $2,999
Used Ford Mustang
591 Great Deals out of 36,166 listings starting at $1,800
Used Chevrolet Blazer
4 Great Deals out of 1,075 listings starting at $950
Used Jeep Cherokee
373 Great Deals out of 51,386 listings starting at $1,995
Used Toyota 4Runner
257 Great Deals out of 22,448 listings starting at $1,750
Used Toyota Land Cruiser
13 Great Deals out of 1,013 listings starting at $5,995
Used Ford F-250
469 listings starting at $2,550

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.