Bearings could be going bad in the blower, it could need replaced. There is also a resistor pack in the air box under the glove box that could also be going bad, usually if the resistor block is going bad, you will lose the slower speeds of the blower but still have full speed.
Thanks for this answer. I have heard about this resister block and I will find out.
My front blower does not work proper. It varies.
2008 Ford Expedition EL Limited
-
Maintenance & Repair
How to reprogram my remote control system on a ford expedition Eddie Bauer ?
2001 Ford Expedition
-
Maintenance & Repair
after soldering a new relay for the fuel pump on the circuit board the blower and temp control don't work, is there a relay for blower and temp control I could have damaged when unsoldering and sold...
2003 Ford Expedition XLT 4WD
-
Maintenance & Repair
I actually had 3 codes when i took to shop they replaced intake gaskets done coolant flush and replaced # 2 sparkplug cause it was cracked do from leak of intake gasket and that was the 3rd code i m...
1998 Ford Expedition 4 Dr XLT SUV
-
Maintenance & Repair
I changed my blower motor it worked then stopped back one blows.i thought it was the front blower I changed it it stopped working after while.my light on panel still light and rear defrost button ...
2003 Ford Expedition XLT
-
Maintenance & Repair
2008 Ford Expedition
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.