Can't engage reverse lockout.

Asked by Nov 12, 2013 at 11:15 PM about the 1968 Ford Mustang Shelby GT350

Question type: Maintenance & Repair

Roll pin came out of reverse lockout lever on my 68 Shelby with 4 speed top loader.  Now I can't get to the lockout shaft.  Any suggestions how to pull the shaft back up so as to be able to engage the pin?

3 Answers

perhaps you can use a strong magnet to pull it around~

compressed air blast?....shop vac??

21,845

from interior, remove boot and surrounding trim, work from there that's about it as far as I know, alignment will still be a little tricky at that

Your Answer

Mustang

Looking for a Used Mustang in your area?

CarGurus has 39,959 nationwide Mustang listings starting at $1,895.

ZIP:

Ford Mustang Experts

  • #1
    Tom Demyan
    Reputation
    4,710
  • #2
    Bob Beaman
    Reputation
    1,340
  • #3
    F_O_R
    Reputation
    1,180
View All

Related Models For Sale

Used Chevrolet Camaro
443 Great Deals out of 31,892 listings starting at $1,450
Used Dodge Charger
473 Great Deals out of 34,069 listings starting at $1,999
Used Chevrolet Corvette
170 Great Deals out of 17,441 listings starting at $3,000

Used Cars For Sale

2018 Ford Mustang For Sale
10,177 listings starting at $21,799
2017 Ford Mustang For Sale
89 Great Deals out of 10,338 listings starting at $13,579
2016 Ford Mustang For Sale
95 Great Deals out of 2,887 listings starting at $11,991
2015 Ford Mustang For Sale
56 Great Deals out of 2,758 listings starting at $12,997
2014 Ford Mustang For Sale
101 Great Deals out of 2,668 listings starting at $9,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.