I HAVE A 2000 WITH TELESCOPE STEERING WHEEL THAT ONLY MOVES WHEN PRESSING SEAT SWITCH. IT ALSO SOMTIMES CUTS POWER, WHEN I SHUT IT OFF AND TAKE KEY OUT AND OPEN AND SHUT THE DOOR IT WILL WORK AGAIN. WHAT CAN I DO

I HAVE A 2000 WITH TELESCOPE STEERING WHEEL THAT ONLY MOVES WHEN PRESSING SEAT SWITCH. IT ALSO SOMTIMES CUTS POWER, WHEN I SHUT IT OFF AND TAKE KEY OUT AND OPEN AND SHUT THE DOOR IT WILL WORK AGAIN. WHAT CAN I DO 1 Answer

OK THE DRIVER SEAT IS SOMETIMEY, AND SOMTIMES I LOOSE POWER TILL I SHUT IT OFF AND REMOVE THE KEY. ALSO STEERING WHEEL SWITCH DOESNT MOVE THE WHEEL BUT THE POWER SEAT SWITCH WILL MOVE THE WHEEL IN AND...

light comes on that say sevice sterring colume and the car only idles and when you take off it cuts off what is the problem 1 Answer

it seems to be a key chip problem or someting maybe to wrong in the computer or maybe some sort of theft device built in can you help

I have a 1976 Corvette with the headlights off the signals work fine! When I trun on the lights the left will not flash and the left front side marker goes out.. 4 Answers

I have a 1976 Corvette with the headlights off the signals work fine! When I trun on the lights the left will not flash and the left front side marker goes out.. not sure what to check next

Stalling when hot... My 1967 427/400 Hp L68 Corvette stalls when I drive it for approx 15 to 20 minutes after a short time it will start back up and do it again. What is the problem? When it run is runs very strong. 6 Answers

My 1967 vet stalls after driving it for approx 15 minutes. If I wait a few minutes it starts back up only to repeat the problem. It has 3/2 barrel Holly carbs and they have been rebuilt. Can it b...

I recently purchased a 1965 Corvette 327. It runs great, but when I shut it off, it runs on, sputters and then eventually will shut down. What causes this and what can I do to correct it? 2 Answers