1987 bronco 2 4wd 2.9 harness from right inside fender to engine an orange wire with an eyelet on the end where would it go to.it turns over but will not start

Asked by Sep 13, 2013 at 04:03 PM about the 1987 Ford Bronco II

Question type: Maintenance & Repair

1 Answer

look between the dip stick tube bracket and the passenger side cylinder head..Should be a bolt for it down there. it's a ground for the O2 system to function properly so it may not start even after you re connect it,

Your Answer

Add photo

Related Questions

Search Ford Bronco II Questions

Ford Bronco II Experts

#1 tennisshoes
tennisshoes
Reputation 580
#2 Andrew Olsen
Andrew Olsen
Reputation 230
#3 Colin Rivet
Colin Rivet
Reputation 220
View All

Related Models For Sale

Used Ford Bronco
203 listings
Used Ford F-150
2,064 Great Deals out of 207,332 listings starting at $1,499
Used Ford Ranger
176 Great Deals out of 5,675 listings starting at $950
Used Jeep Wrangler
261 Great Deals out of 16,543 listings starting at $2,590
Used Chevrolet Blazer
3 Great Deals out of 1,188 listings starting at $1,820
Used Ford Mustang
543 Great Deals out of 45,845 listings starting at $1,999
Used Toyota Land Cruiser
11 Great Deals out of 1,034 listings starting at $3,700
Used Jeep Cherokee
470 Great Deals out of 43,867 listings starting at $2,497
Used Chevrolet Camaro
242 Great Deals out of 31,193 listings starting at $369
Used Ford Thunderbird
19 Great Deals out of 1,072 listings starting at $5,991
Used Toyota 4Runner
260 Great Deals out of 19,017 listings starting at $2,500
Used Chevrolet S-10
5 Great Deals out of 1,311 listings starting at $2,400

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.