1990 GMC Vandura 2500

Asked by Apr 16, 2017 at 11:06 PM about the 1990 GMC Vandura

Question type: Maintenance & Repair

I have a van that I was driving and it started getting hot,
but it died at a stop light before I could get off the road.
Since then, I haven't been able to start it without starter
fluid. It will run while I'm giving it gas, but then dies. I
don't know a lot about vehicle repair, so I don't even know
where to start. Can anyone point me in the right direction?

2 Answers


First thing is run a compression check, if it got hot enough to die on the road chances are very high that piston ring damage has occurred, in other words the rings lost thier tension from the heat. So your compression will be low and the starter fluid adds just enough extra flash to get it running but won't maintain combustion when the incoming fuel mixture drops into idle circuit. Note there maybe other engine management componets also damaged by the heat but you won't find that until the engine is back operational specs.

Thank you. I won't be able to get to it for a couple of days but I'll try that out.

Your Answer

GMC Vandura Experts

  • #1
    Tom Demyan
  • #2
  • #2
    John Saffrahn
View All

Related Models For Sale

Used Chevrolet Chevy Van
51 listings starting at $5,990
Used GMC Safari
102 listings starting at $1,800
Used Chevrolet Astro
211 listings starting at $1,495
Used Dodge Ram Van
101 listings
Used Ford F-150
3,332 Great Deals out of 221,764 listings starting at $1,200
Used Ford Bronco
207 listings

Used Cars For Sale

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.