1999 Sebring Won't start
accidentally pulled out ASD fuse and car shut off in 10 seconds
When I replaced the fuse, the car would not crank & start afterwards
Crank, spark & fuel pressure now gone
"ccd" appears on display
What's up ?
Try disconnecting one of the battery cables and wait at least 30 seconds then reconnect the cable, this will reset the computer back to factory defaults. Note this may trigger the alarm if equipped, so make sure you know how to turn it off before performing this action. Then try to start the engine, it may run a little different for a while until the computer relearns the vehicle and how you drive, usually takes about 20 minutes of drive time to do so. HTH
Did that many times...even replaced ECM I had been having trouble with key/anti-theft system/alarm for some time prior...and poss BCM prob ?
Either that or a buss connection between the ECM and the BCM, have you checked the codes?
"Cannot communicate with ECM" That's why we replaced it But still same response
The first thing to check is the ECM to BCM wiring harness, look for any chaffing or rubbed through wiring, even a bad harness ground can cause trouble.
K That's what I'll do... Next... In near future Thx Will get back in day or two Thx again
Looking for a Used Sebring in your area?
CarGurus has 3,780 nationwide Sebring listings starting at $1,994.
Search Chrysler Sebring Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
Chrysler Sebring Experts