Ford LTD Crown Victoria Questions Any type
- Recently Active
I have a 91 crown Vic LTD that has been sitting for a year. I just got it back on the road after changing the alternator, new battery, new selonoid and I fixed the exhaust manifold leak.. when I cr...
What would be the best way to remove the fuel sending unit on my 1983 Crown Victoria
I have a 1986 Ford LTD Crown Victoria with a fuel injected 5.0 302. It had sat for an unknown amount of time prior to purchase in Feb. 2016. This car was love at first sight and I had to have it. ...
Hi, So my wagon is running and on the road. one item to sort out is the high idle speed. In part it sometimes idles nice but sometimes way too fast. When I put it in drive or reverse (load up the eng...
I have an 83 ford ltd crown vic, put on new fuel pump, plugs, wires, hear the fuel pump but no gas getting to motor
I just picked up this car from a family member. The engines turns over no issue. The TFI is new as is the coil. I have 12 volts at the coil. But no fire from the coil to the distributor. Any help is ...
I have a 1987 ltd Ford Crown Victoria i was just wondering what type of transmission i need it's two type. Pictures would be helpful
My throttle body is cracked where the fuel line attachment screws into the throttle body on the inlet pressure side is there a way to seal this crack would hate to have to buy a whole new piece seeing...
On my alternator there is a single wire that isn't bolted on when left off car runs perfectly but leaves the amp light on but when I plug the wire onto the bolt that it goes to car tries to start but ...
when i get up to 45 mph the car rpms very high. it doesnt switch gear after that. the car has a strong take off. it feel like my over drive is gone
screws upside down cant reach. best way needed.
I just purchased a 1988 Ford Crown Vic LX, and I'm looking for where to buy a kit of all the tubes. The current tubes are crumbling when I touch them, and I would like to buy a kit. I'm currently re...
When I cut the switch on every fuse in the fuse box has power and my starter starts to crank the car without me trying to start the car so starter wire has a continuous power
The intake manifold gasket for a Ford 302 cid engine has a center hole between the 2 central bolting holes. What is this center hole for ?
Search Ford LTD Crown Victoria Questions
Ford LTD Crown Victoria Experts
Related Models For Sale