Chevrolet C/K 2500 Questions Any type
- Recently Active
We have changed the fuel filter, ECM box checked the tbi injectors. Put tester on the fuel line go to fuel pump reading 5 psi. Fuel pump does not run with the key on, only pumps when cranking. Change...
plugged off fuel line to the injectors
And they are working the fuel pump is pumping up fuel. we have now changed the ECM box. It will start with starting fluid. Not sure what else to check?
Truck stalls when hitting the gas at idle and in gear unless you ease into it. Only way to get it to start again is to crank it over with the gas pedal pressed all the way to the floor. Hard to st...
reads about 9 volts. Could it be a ecu box? Or fuel pump? Or something else?
My truck just threw a multiple cylinder misfire code (PO300) and when I turn right. and only right it shudders. It feels like its not getting enough gas. Ive changed multiple parts( 02 sensors, egr, f...
i have an 89 Chevy c/k 2500 with a 305 and we are swapping the motor on it and the motor is from an 84 and when we went to put the intake on the middle bolts won't line up, i was wondering if it can...
I have no idea if I have an aftermarket thermostat or not, and it takes quite a while to get heat. Is this normal? Any suggestions are greatly appreciated
I cranked the torsion keys all they way up, but it still did not level it because I have oversized lief springs in the rear for towing. I purchased the newer torsion keys but my upper control arms a...
Put truck in drive or reverse and it sits there for few seconds then will ingage but stills sounds like it not totally in gear shifts fine going down the road it's an automatic
Search Chevrolet C/K 2500 Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
Chevrolet C/K 2500 Experts