Why is my 97 probe 2.0 automatic pulling to the right only during acceleration

Asked by Dec 14, 2014 at 07:34 PM about the 1997 Ford Probe STD

Question type: General

1 Answer

There is a few reasons this can occur.One is a loose or damaged motor or trans. mount. These can cause the whole driveline to shift upon acceleration by putting torque on the engine/trans which the cv joint is connected to. Also, a bad cv (constant velocity) joint . In this case I would have the whole driveline examined as this is a front wheel drive vehicle and numerous parts can be bad or worn.If you take it in for a front end alignment, most shops check ALL the front end parts before doing a front end alignment.Free of charge.At least you'll get an answer to your problem.

Your Answer:

Ford Probe Experts

  • #1
    Patricia Moore
    Reputation
    130
  • #1
    Tom Demyan
    Reputation
    130
  • #3
    lindspa
    Reputation
    90
View All

Related Models For Sale

Used Ford Mustang
266 Great Deals out of 37,717 listings starting at $1,350
Used Chevrolet Camaro
237 Great Deals out of 27,287 listings starting at $2,077
Used Mitsubishi Eclipse
22 Great Deals out of 859 listings starting at $1,350
Used Mazda MX-5 Miata
54 Great Deals out of 4,636 listings starting at $1,900
Used Honda Civic
366 Great Deals out of 49,151 listings starting at $500
Used Chevrolet Corvette
96 Great Deals out of 15,044 listings starting at $3,620
Used Nissan 240SX
12 listings
Used Ford F-150
2,300 Great Deals out of 208,485 listings starting at $1,300
Used Toyota Supra
60 listings
Used Ford Thunderbird
18 Great Deals out of 1,074 listings starting at $6,498
Used Ford Focus
390 Great Deals out of 80,763 listings starting at $1,300

Used Cars For Sale

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.