How do u reset the computer after replacing the camshaft sensor and still wont start but turns over

How do u reset the computer after replacing the camshaft sensor and still wont start but turns over 3 Answers

what's it mean when u disconnect the negetive trerminal for 20 minutes to reset pcm/ecm and the codes are still the same after that? 4 Answers

I disconnect the battery to reset the pcm/ecm but the codes are still there.and if I tap the negative cable to the post several times my truck starts up but dies in a feew seconds.

i have 1997 dodge 1500 5.9 liter, wont start, i put new camshaft sensor, new crankshaft sensor, new rotary cap, new rotary cap button, new coil, still wont start, what could be the problem? and fuel pump is not kicking in 3 Answers

i put new camshaft sensor, new crankshaft sensor, new rotary cap, new rotary cap button, new coil, and fuel pump wont start

1996 dodge ram 1500 won't start or turn engine over after replacing the starter 1 Answer

Drove truck last week it ran fine. Pull truck out of the driveway and went down the street it made a clunk, clunk noise and shut off. I thought right off it might be the starter, so I change the start...

1996 ram 1500 5.9 turns over wont start need help 76 Answers

truck started out running fine but would randomly die. wait a few minutes and would usually fire right back up. then it would randomly die again.. now it only turns over.no fire.tried a snap on diagno...