Break

Asked by Dec 27, 2015 at 12:26 PM

Question type: Maintenance & Repair

Replace the master cylinder and
now I have nothing for breaks
when I put the break pedal down

3 Answers

10

You have to bleed the air out of the brake lines.

1 of 1 people found this helpful.
46,415

Usually a replacement master cylinder is bench bled before installation in the vehicle. This will minimize the air in the system.

1 of 1 people found this helpful.

Tx Alot Guys. A work a had Alot of air now I replace the powerstaring pump and now my belt make noise I replace pull and still making noise am a buy a new belt even if the belt seen new. Why u think

Your Answer

Add photo

Related Questions

  • Breaks 5 answers

    My breaks went all the way out I have to use the emergency break to stop

    1992 Chevrolet Caprice Classic

    -

    Maintenance & Repair

  • Breaks 1 answer

    After my radiator cracked and I replaced it now I have no breaks all of a sudden

    1986 Ford F-100

    -

    Maintenance & Repair

  • breaks 5 answers

    How do you tighten rear drum breaks on Toyota Starlet '96

    1996 Toyota Starlet

    -

    Maintenance & Repair

  • Breaks 1 answer

    my breakes if depressed to hard skipp and jerk the truck

    Maintenance & Repair

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 169,100
#2 dandyoun
dandyoun
Reputation 91,650
#3 tenspeed
tenspeed
Reputation 73,940
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.