How to replace the "D" bulb on the PRND21 shifter for a 2003 Toyota Sequoia

Asked by Feb 20, 2012 at 02:56 PM

Question type: Maintenance & Repair

1 Answer

60

Disconnect Your Battery First Wait 5 minutes Remove Gauge Bezel-Tilt the steering column to it's lowest position. Remove the two screws along the top of the bezel-look up from seat level. Pry carefully at the lower sections of the bezel with a screwdriver to release the clips on the bottom. Grasp the bezel and set it aside Remove the bolts attached to the white part of the instrument cluster, there are four of them. Carefully disconnect the electrical connectors that are attached to the back. Remove the instrument cluster On the Rear of the instrument cluster lights can be identified as black circles with a rectangular section protruding from the middle. Locate the light you wish to replace and grab the rectangular section and twist it to the left, the bulb is now free and ready to be replaced. Installation is reverse. Now connect the battery Do Not Connect Battery Until Job Is Complete

4 of 4 people found this helpful.

Your Answer

Shortcuts

Maintenance & Repair Experts

  • #1
    Tom Demyan
    Reputation
    177,490
  • #2
    dandyoun
    Reputation
    94,420
  • #3
    tennisshoes
    Reputation
    77,140
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.