92 bronco: how do i take off the whole hub assembely?

Asked by Aug 11, 2013 at 04:31 PM about the 1992 Ford Bronco

Question type: Maintenance & Repair

i have taken out the locker, the axle nuts, and removed the outer bearing so i could pull the whole hub assembely off. but when i went to slide it off it seems to be catching on something? now i have done this before to change the bearings and its never stuck like this. almost seems like the inner bearing is stuck on the axle shaft?
any suggestions?

1 Answer

25,315

Sorry, no suggestions. I've seen many of those hub and half- shaft assemblies replaced though. Not cheap as I recall.

Your Answer

Ford Bronco Experts

  • #1
    tennisshoes
    Reputation
    430
  • #2
    Js08016
    Reputation
    170
  • #2
    Clayton Cameron
    Reputation
    170
View All

Related Models For Sale

Used Ford F-150
2,234 Great Deals out of 183,024 listings starting at $1,500
Used Ford Mustang
770 Great Deals out of 42,663 listings starting at $1,300
Used Jeep Wrangler
279 Great Deals out of 15,911 listings starting at $2,997
Used Chevrolet Blazer
4 Great Deals out of 1,153 listings starting at $950
Used Ford F-250
477 listings starting at $1,295
Used Ford Explorer
796 Great Deals out of 63,363 listings starting at $1,495
Used Ford Ranger
169 Great Deals out of 5,540 listings starting at $1,000
Used Toyota 4Runner
244 Great Deals out of 21,760 listings starting at $1,500
Used Chevrolet Camaro
419 Great Deals out of 31,911 listings starting at $2,395
Used Jeep Cherokee
401 Great Deals out of 41,245 listings starting at $1,800

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.