brake lights not working on 1963 ford falcon

Asked by Oct 31, 2013 at 10:47 PM about the 1963 Ford Falcon

Question type: Maintenance & Repair

3 Answers


There were 2 systems used, 1 was a switch under the dash that was attached to the brake pedal and the other was a switch that was screwed into the master cylinder under the hood, as both system had switch problems that would be the place to start, make sure that they have power in and power out when the pedal is depressed, if you have power in but not out replace the switch, if you have power through the switch then double check your turn signal switch as the turn signal switch cancels brake light on right or left turn but it maybe bad and cancelling both lights. Hope this helps.


On a 1963 the switch is down on the brake pedal. It just may be out of adjustment. The bracket and the plastic get old and slip down. better off just replaceing the brake light switch on the back side of the brake pedal


In 1965 I belave it was they put a switch in the master but that had nothing to do with the brake lights it was there to let you know your brake fluid level was laow. Hell they still use that system on Fords

1 people found this helpful.

Your Answer:


Looking for a Used Falcon in your area?

CarGurus has 36 nationwide Falcon listings and the tools to find you a great deal.


Ford Falcon Experts

  • #1
    Troy Witt
  • #2
  • #3
View All

Related Models For Sale

Used Ford Mustang
296 Great Deals out of 39,978 listings starting at $1,312
Used Ford Fairlane
86 listings
Used Ford Galaxie
121 listings
Used Chevrolet Impala
525 Great Deals out of 26,142 listings starting at $995
Used Chevrolet Nova
155 listings
Used Ford Thunderbird
17 Great Deals out of 1,076 listings starting at $6,498
Used Ford Ranchero
44 listings
Used Mercury Comet
21 listings

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.