Brake pedal is low on first pump and will go to floor under pressure, but will stop the van,it has new calipers and new master cylinder

Brake pedal is low on first pump and will go to floor under pressure, but will stop the van,it has new calipers and new master cylinder 4 Answers

I have a 94 E-350, Has RABS Brakes, the brake pedal goes to the floor, new master cylinder no change 4 Answers

Even after a new master cylinder pedal still goes to the floor. How to diagnose RABS brake system.

i have a 1991 econoline van, i recently put a new starter,alternator,battery,selonoid,battery, cables, ( which i had to use an extention on the cables ground to hook it to the original ground on the engine) my problem is when i drive and stop it won't start back up but if it sits for about an hour it will start again, but now it seems that the battery is run down and i have to re-charge the battery for over 5 hours and it didn't take a full re-charge any suggestion. thank you 1 Answer

i recently put a new starter,alternator,battery,sel... battery cables,and it wont keep a charge, when i drive it and stop it wont start back up sometimes if it sets a while it will start back up and n...

what would cause the temp gauge in my 1985 Ford E150 to go to hot when lights are turned on, wipers are turned on, brake pedal is depressed, heat is turned on, or van put in reverse? 8 Answers

when I start the van and run it without running any of the "accessories" the temp gauge stays right in the middle of the normal range. However, when ever I turn on just one of these "accessories" (...

The gas guage on my van is stuck on full. I also have decreased starting power from a stop. Are the problems related and what do I need to do to fix it? 1 Answer

My van takes 10-15 seconds to regain full power after stopping at a light or from any stop. The guage issue and power loss started at the same time.