Why does my 1994, 4 cylinder, chevy corsica stall out when I use the brake pedal?

Asked by Feb 15, 2012 at 02:36 PM

Question type: Maintenance & Repair

have to jump it to start it. Runs fine until I use the brake pedal then it stalls out. Then I have to repeat the process. Any suggestions on what the problem is?

1 Answer

1,275

You might have a problem with the brake servo and the vacuume pipe or vacuume servo. Best the get a garage to have a look at it.

Your Answer

Add photo

Related Questions

  • Brakes 3 answers

    Why does brake pedal go to floor after master cylinder replaced

    1978 Chevrolet Chevy Van

    -

    Maintenance & Repair

  • I HAVE N0 BRAKES 3 answers

    MY ABS LIGHT STAYS ON ALL THE TIME. THE PEDAL GOES TO FLOOR,I CAN'T GET IT TO PUMP UP

    1994 Chevrolet Corsica 4 Dr STD Sedan

    -

    Maintenance & Repair

  • Why does my right blinker stop when i push the brakes? 4 answers

    I have a 1991 Chevy corsica and when i put the right blinker on, all of the rear lights flash as if i'm tapping on the brakes. also when i push on the brakes, nothing flashes. I've checked all the con...

    1991 Chevrolet Corsica 4 Dr LT Sedan

    -

    Maintenance & Repair

  • why won't my gear come out of park when I mash brake pedal 2 answers

    I have a 1993 chevy gladiator van and it doesn't want to come out of park when I hit brake pedal unless I turn off engine and put in neutral.

    1993 Chevrolet Chevy Van

    -

    Maintenance & Repair

  • 1988 Chevy Corsica 2.8

    I used to have a 1988 Chevy Corsica and I bought it used after my 4 cylinder Chevy celebrity got totaled rear ended. It wasn't a bad car when I got it was solid and dependable. But later on started...

    General

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 165,800
#2 dandyoun
dandyoun
Reputation 90,480
#3 tenspeed
tenspeed
Reputation 73,320
View All