Rocam engine won't start
I have bantum 1.6 rocam engine, I recently had
piston rings changed, a week later while driving
bolt holding cap on piston rod 3 ,broke and broke
the oil sump and engine block, I had another
subassembly but it's 1.3, the 1.6 head fits but it just
cranks and not starting, it can't be wiring because
everything was fine before it broke the block. Can it
possibly be the crank sensor or pcm since I used
the one from 1.6 block?
Fit the original fly wheel. There is a difference between the Pre 2007 and the 2007 onwards models. Pre 2007 have 36 minus 1 teeth and 2007 onwards have 36 minus two teeth. The 1300 has a knock sensor and the 1600 does not (if its a 2005 model) The 1600 does not have the knock circuit on the PCM board as the 1300 does. If the conrods are replace, there should be NEW Bolts as these are streach bolts. Is the "New" block off a 2007 onwards Bantam ?
It is a 2005 model 1.6i XLT, I have used my 1.6 head on 1.3 subassembly, flywheel is also for 1.6 and crank sensor. The 1.3 is pre 2007 Thanks in advance
Search Ford Bantam Questions
Ford Bantam Experts
Find great deals from top-rated dealersTMSearch