egr valve

5

Asked by May 16, 2011 at 03:35 PM

Question type: Maintenance & Repair

i put on a new egr valve on  and i put 50 miles on the vehicle the check engine light came back on setting a code po 401 i need a diagram of the vacum lines going to this chyrsler town and country van egr system could i put a vacum line in the wrong place to set this code.

1 Answer

3,045

did you reset the computer after you replaced the valve ? Unhook the positive cable from battery for fifteen seconds ,then reconnect . vacuum line error is possible but if it's like most newer vehicles the lines preety much route themselves . If one is stretched or hass too much slack I'd start looking there .

Your Answer

Add photo

Related Questions

  • Where is egr valve? 1 answer

    replacing of egr valve.

    2001 Ford Crown Victoria

    -

    Maintenance & Repair

  • EGR Valve, 10 answers

    The check engine light came on and when I pulled the codes on the truck it indicates that the EGR Valve needs repaired. How do you repair the EGR valve?

    Toyota Tacoma

    -

    Maintenance & Repair

  • where is the EGr valve on the 2002 nissan Maxima 1 answer

    where is the EGR valve on a 2002 nissan Maxima

    2002 Nissan Maxima SE

    -

    Maintenance & Repair

  • Location of egr valve on 2000 mountaineer 3 answers

    Location of egr valve and what purpose does it serve

    2000 Mercury Mountaineer 4 Dr STD AWD SUV

    -

    Maintenance & Repair

  • Egr valve 1 answer

    I have a 2001 chysler voyager 2.4 liter. When the egr vacuum line is hooked up the engine stalls. It's brand new. Without it the engine starts hard.

    2001 Chrysler Voyager 4 Dr STD Passenger Van

    -

    Maintenance & Repair

Shortcuts

Search Maintenance & Repair Questions

Maintenance & Repair Experts

#1 Tom Demyan
Tom Demyan
Reputation 150,710
#2 FordNut
FordNut
Reputation 103,420
#3 dandyoun
dandyoun
Reputation 84,400
View All