Jeep CJ-5 Questions Maintenance & Repair

Cj5 Carburator Carter Bbd Engine Won't Idle

I Have A 1980 Jeep CJ5 W/ 304V8. I've Replaced The Starter, Starter Solen...

After replacing everything I can possibly think of, I considered an ignition fuse might be blown or tripped, but I can find none and can find no reference online. Is there an ignition fuse and if...

1980 Cj5 2.5l 4 Cylinder Headlight Ground Wires

I cannot find the ground wires on my cj5, going down the road and I lost all my lights...please help!

79 Cj5 I6 4.2 Not Getting Fuel To The Carb

My cj5 is getting fuel through all the lines but stops at the carb and won't start if I prime it it starts for a second but dies it has the inline 6 4.2

Cj5 Jeep

My cj5 jeep has a 258 inline 6 it runs fine until you get over 45 then it cuts out and back fires out the exhaust if you stay on the gas what could be the problem

Why Is My Starter Not Disengaging After The Vehicle Is Running?

i have a 1979 jeep cj5 on 38's with a 360 v8. Yesterday i was driving to school and the jeep acted like it was running out of gas, sputtering very bad. I pulled in the gas station and it only took t...

Please Help With My 1959 Jeep CJ5

I'm having trouble finding the correct front wheel cylinders and brake hoses for my 1959 Jeep CJ5. Mine were angled where the hoses screwed in to the wheel cylinders and I'm only finding straight ho...

Why Will My 81 Cj5 Only Go Into Gear When Not Running?

Jeep ran fine before we replaced the engine. Engine now runs fine but when the guys backed it out of the garage to take for a test drive it somehow got turned off (I don't remember if it shut off o...

I Have A 1965 Jeep CJ5 With The Stock 4 Cylinder Engine.I Want To Set The T...

1982 CJ5 Starts And Idles Fines, Once Put Into Gear It Randomly Dies. It Wi...

Could this be the float valve in the carburetor? or something more sinister? I haven't had a lot of automotive repair experience but I'm a quick study. Any helpful advice is much appreciated. Thanks

Clutch Problem

worked fine one day next time got in it clutch would not work replaced clutch throw out bearing and pressure plate but clutch still does not work even after ajusting everything out to max does anyone ...

79 304 Backfires

Engine backfires on the right side only. It has a new carb and intake manifold (old system had same problems)Engine burns some oil on acceleration and startup The problem developed after a 60 mile dri...

77 Cj5 308 V8 Dies When Driving

My jeep dies while driving I take fuel filter off and reinstall and it fires right up and runs for a day or two till dies again

1979 Cj5 4x4 Manuel Hubs How Do I Replace Front Wheel Bearings??

I need a parts list for replace bearings

Head Lights

Have a 75 cj5. When on low beam only driver side works put it on high beam both work have checked fuses, replaced all bulbs, even replaced the floor dimmer switch. Any ideas on what I'm doing wron...

Will A 1959 Shop Manuel Show All Chassis Nuts, Bolts, Washers Etc And Diagr...

i'm doing a frame-off restoration on a 1959 jeep cj5 and need detailed chassis diagrams with nuts, bolts etc.

Output Shaft Too Long

I had a transmission built by Monster in Florida. I live in Mass. the output shaft is 2" too long. What are my options? They want a 25-50% restocking fee and for me to pay for return shipping so that'...

Ignition

i have a 1975 jeep cj5 with amc bid ignition it works fine,i bought a after market ignition module as a spare pluged it in it didnt work,got a replacment it didnt work,got a third replacement , didnt ...

2.5l Jeep

Is the block the same in 82 as in 95 2.5l 4cyl

The Counterweight Pins In My Distributor Keep Falling Out. I Have Tried Thr...