Jeep Questions Any type
- Recently Active
Lost lights, dash and exterior clearance lights. Headlights, turn and brake lights work fine. Light bulbs good. Tried changing headlight controller but no difference. Did notice when I turn on the rea...
My jeep cuts off while driving down the road. However, I can immediately crank it right back up. It seems to happen after I have driven the vehicle for a few miles and when I slow down before comi...
The 4 wheel drive light stays on even when placed in 2 wheel drive
My 4 wheel drive light on stays on even when place in 2 wheel drive
i have a 99 grand cherokee with 4.0 and 42re trans that just completely stopped working. i replaced the trans myself and while taking old one out i forgot to unplug camshaft position sensor and brok...
I just bought this car from a friend a little over a week ago, and have had no trouble with it but on the way home today it started smoking and had this smell. Gages read normal it wasn't over hea...
have already replaced the blend doors. they were broken. they are working properly now. heater core good. new radiator. engine temp 210 deg f. if I pull it in my garage, maybe 50 deg or so heat will ...
99 jeep grand cherokee limited 4 litre auto 4x4 shifts perfect 1st to 2nd will rev over 3500 rpm between 2nd and 3rd have to let off on the gas pedal to allow it to shift,,after thatit shifts fin...
It will start right up and drive for a few miles then quits. Will not restart untill its sit for an hr or so. Already replace fuel pump, pressure regulator, and fuel filter.
I have a 2000 jeep grand cherokee, in great shape and we love it. But since it is a bit older, the grey/black lower part and bumpers of the jeep has totally faded. We have tried armarol and other prod...
I can not see how you mount a set of nerf bars on a 2006 liberty or steps unless you have to drill holes, my wife is short so I need some sort of step
Everytime I use my left turn signal only, the overhead lights come on. When the signal goes off, 5 seconds later, the lights turn off. I'm hoping this is a simple issue but could use some advice on ...
from the looks of the motor it is original I am doing the rebuild myself but what to make sure I order for the right size
Favorite this topic
Subscribe to Jeep questions.
Search Jeep Questions