Mazda MX-6 Questions Maintenance & Repair

  • Newest
  • Recently Active
  • Unanswered
mdplourde
0

Why Is My 1996 Mazda Mx6 2.5l Shaking When Accelerating And Feels Like It's...

This morning on my way to work, my car felt as if it wasn't getting enough fuel/air when pressing the gas pedal to get enough power. When I would accelerate, the car would feel shaky and felt as if ...

29 views with 3 answers (last answer 4 days ago)
Locopato
0

Car Stalls When I Went To Change Gear

My mazda MX6 automatic was running well until last night when i went to change gear into drive it turned off. It turns on ok and when i change gear it turns off, took it to the shop and they dont kn...

dadfixit
0

How Much Oil Should I Put In A 1988 Mx6 Gt 5 Speed ?

Need to know how much oil in the trans 88 MX6 GT 5 speed.

yardessence
5

Strong Air Flow But No Heat In Cabin

Not sure if my problem maybe the blend door. I did the following checks based on my problem regarding no heat in cabin. Air flows quite well but not warm/hot. Checked the hoses from heater core both h...

65 views with 4 answers (last answer about a month ago)
Shirftoom
0

How Do I Remove Alternator In Mazda Mx6 1992 2 Door

How to replace alternator in mazda mx6 1992

27 views with 1 answer (last answer 2 months ago)
yardessence
5

Coolant Air Separator (substitute) 1993 Mx6 V6

Part 1 of 2 pt question. Does anyone know of a substitute for the coolant air Separator tank. Mine has a crack and is currently leaking coolant I'm concerned that if I buy the exact replacement part i...

Arturo Ontiveros
0

Where Is Transmission Filter

21 views with 2 answers (last answer 3 months ago)
tooltime71
0

Does A 1994 Mazda Mx6 Have A Distributor Problem?

1994 mazda mx6 V-6

45 views with 2 answers (last answer 3 months ago)
yardessence
5

Temperature Guage Not Working??

How do I test the temp guage?? In the morning after the engine has been cool overnight. I turn the key to accessory and immediately within 2 seconds the needle goes 1/3 the way and stays there. Even a...

56 views with 1 answer (last answer 7 months ago)
yardessence
5

Ac Oil To Freon Ratio 1993 Mazda Mx6 V6 2.5l

Is there a way to measure these fluid levels already in the system so ratio will be good and not have too much/little oil for example. Can anyone help me learn what the AC system ratio of oil to refr...

32 views with 2 answers (last answer 7 months ago)
old3167
0

Mx-6 Dies@idle

runs ok above 1700rpm, new fuel filter no change,no vacume leaks help

75 views with 1 answer (last answer 11 months ago)
smitron
0

1988 Mazda Mx 6 Alternator Removal

83 views with 1 answer (last answer about a year ago)
Pp666
0

Location Temperature Sensor

177 views with 3 answers (last answer about a year ago)
snowmanfrosty
0

What's The Cost Parts And Labor To Replace Pully On 94 Mazda Mx 6 V6

it was rattling and sounded as if bearings were bad, it completely stopped spinning and car sounded awful. engine and transmission always have run good. doesn't use oil.

87 views with 1 answer (last answer about a year ago)
Christopher Mamoepa
0

My Alternator Don't Charger My Battery

151 views with 4 answers (last answer about a year ago)
smcphee
0

How Do I Remove The Alternator??

296 views with 1 answer (last answer about a year ago)
1 2 3 next

Favorite this topic

Subscribe to Mazda MX-6 Maintenance & Repair questions.

Shortcuts

Search Mazda MX-6 Questions

Mazda MX-6 Experts

#1 lightGear
lightGear
Reputation 100
#2 Tom Demyan
Tom Demyan
Reputation 80
#3 Richard Boettger
Richard Boettger
Reputation 60
View All