Mazda MX-6 Questions Any type

  • Newest
  • Recently Active
  • Unanswered
dadfixit
0

How Much Oil Should I Put In A 1988 Mx6 Gt 5 Speed ?

Need to know how much oil in the trans 88 MX6 GT 5 speed.

yardessence
5

Strong Air Flow But No Heat In Cabin

Not sure if my problem maybe the blend door. I did the following checks based on my problem regarding no heat in cabin. Air flows quite well but not warm/hot. Checked the hoses from heater core both h...

Shirftoom
0

How Do I Remove Alternator In Mazda Mx6 1992 2 Door

How to replace alternator in mazda mx6 1992

17 views with 1 answer (last answer 4 weeks ago)
yardessence
5

Coolant Air Separator (substitute) 1993 Mx6 V6

Part 1 of 2 pt question. Does anyone know of a substitute for the coolant air Separator tank. Mine has a crack and is currently leaking coolant I'm concerned that if I buy the exact replacement part i...

Arturo Ontiveros
0

Where Is Transmission Filter

15 views with 2 answers (last answer about a month ago)
tooltime71
0

Does A 1994 Mazda Mx6 Have A Distributor Problem?

1994 mazda mx6 V-6

27 views with 2 answers (last answer about a month ago)
Kristina Miller
0

Where Is The Fuel Filter On A 1988 Mazda Mx 6

6 views with 1 answer (last answer 2 months ago)
yardessence
5

Temperature Guage Not Working??

How do I test the temp guage?? In the morning after the engine has been cool overnight. I turn the key to accessory and immediately within 2 seconds the needle goes 1/3 the way and stays there. Even a...

50 views with 1 answer (last answer 5 months ago)
yardessence
5

Ac Oil To Freon Ratio 1993 Mazda Mx6 V6 2.5l

Is there a way to measure these fluid levels already in the system so ratio will be good and not have too much/little oil for example. Can anyone help me learn what the AC system ratio of oil to refr...

29 views with 2 answers (last answer 5 months ago)
old3167
0

Mx-6 Dies@idle

runs ok above 1700rpm, new fuel filter no change,no vacume leaks help

67 views with 1 answer (last answer 9 months ago)
smitron
0

1988 Mazda Mx 6 Alternator Removal

74 views with 1 answer (last answer about a year ago)
smcphee
0

How Do I Remove The Alternator??

265 views with 1 answer (last answer about a year ago)
Pp666
0

Location Temperature Sensor

164 views with 3 answers (last answer about a year ago)
snowmanfrosty
0

What's The Cost Parts And Labor To Replace Pully On 94 Mazda Mx 6 V6

it was rattling and sounded as if bearings were bad, it completely stopped spinning and car sounded awful. engine and transmission always have run good. doesn't use oil.

79 views with 1 answer (last answer about a year ago)
1 2 3 next

Favorite this topic

Subscribe to Mazda MX-6 questions.

Search Mazda MX-6 Questions

Mazda MX-6 Experts

#1 lightGear
lightGear
Reputation 100
#2 Tom Demyan
Tom Demyan
Reputation 80
#3 Richard Boettger
Richard Boettger
Reputation 60
View All