Chevrolet C/K 10 Questions Any type
283 Rebuild
Could I rebuild my 283 with only a line hone, crank bearings, cam and cam bushings, rod bearings and piston rings? Cylinder bore and pistons look good. Crank has been turned to "0.20. I wanted to go...
1966 C10 Chevy Truck
losses power when i turn on ac and lights at same time
No Power At Fuse Box
Installed new harness in 78 C10 pickup from summit racing #10205 kit, used manual supplied in kit' wired it according to manual, everything connected and working until I tried to start it up. All at...
Starting Issues
I have an 84 chevy c10 with a 250 inline 6. It was working just fine all day but tonight when I parked it. And tried to start it again. It did absolutely nothing. Didn't try to turn over. Starter ...
1970 Ck/10
What additive would you reccomend to put in gas tank to dry (water) and condesation
Heads
Would you get any HP difference putting 400 stock heads on a stock 350
1972 Chevy C10 With A 350 Hei Conversion Harnesses Alternator Not Charging ...
1972 Chevy C10 with a 350 hei conversion harnesses alternator not charging and when key off engine still runs.
Brakes And Hazardes
I have a 75 chevy k10 when i turn my head lights on my hazards or my brake lights wont work what can be the problem
Horn/Steering Wheel
I have a 78 chevy k10 and my main question is how do I get my horn to stop honking and fix the problem. It all started when my turn signal switch broke, I fixed the switch and when I went to put m...
I'm Lost
Changed the plugs on my 85 c10 after doing so truck will not start turns over but no fire off.. it gets fuel no vacuum leaks cap plugs right. After I did the plugs it wouldn't start I ran down the ...
1978 Chevy C10
My 1978 C10 Has the original 250 Straight 6,It's been smelling like its running Rich for the last week or so,Just wondering what could be the cause of that and how to fix it,And Sometime when I sh...
My Truck Is Backfiring From The Exhaust And Flames Were Coming Out From The...
What are the correct settings for the screws on the 4 barrel quadrajet carb and the screws for the throttle and the screw on the linkage for the electric choke. It seems like it might be putting t...
85 Chevy 4.3 Liter V6
Got bad gas at pick quick it runs rough in park and in drive I put veet water remover fuel stabalizer and octane boost checked egr it had some carbon I cleaned it. I had to raise the idle and tim...
I Have A 1984 Chevy K10 With A 305. I Just Bought A Newly Reman Quadrajet 4...
So I put this reman quadrajet 4bbl on my 305. I can get it to idle good in park but as soon as it goes in gear, it runs rough. So I adjusted the fast idle up to compensate but now when i cut the tru...
Water Pump
Changed water pump. Truck was running good no knocks, no smoke. Drove around town no problems, next mo truck just cut off on highway. Will turn over but not start. Any ideas?
86 Chev Died Mid Corner And Wouldnt Start
My 86 chevy k10 stalled in the middle of a merge and wouldnt start back up. As soon as i gave it gas while coming out of the bend the engine just died all of a sudden, there was 0 warning. It would...
Problems Accelerating Past 30
Idels great get up to 30 quickly but just won't accelerate any past with it to the floor what could be the issue
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.