You can’t it is an internal part of the BCM. You will have to install resistors on each LED to prevent hyper flash. Just make sure you keep them away from plastic as they get hot and secure them to metal for better heat transfer. Had to do this to my Silverado when I went LED.
I changed my standard bulbs to LEDs. Now it is hyperflashing. I would like to replace the relay with an LED compatible relay
2018 Chevrolet Tahoe LS RWD
-
Maintenance & Repair
Hey guys have a quick question. I have a 2002 Chevy Tahoe 4x4 LS 5.3 with the 4L60E transmission just bought it. When you start it everything works as it should. When you put it in reverse or drive ...
2002 Chevrolet Tahoe LS 4WD
-
Maintenance & Repair
I replaced the brakes on my wife's 2015 Chevy Tahoe, I noticed on one of the rear calipers there way a dent with a small crack on the center ring, I compressed the ring and pumped the brake and the ...
2015 Chevrolet Tahoe LTZ RWD
-
Maintenance & Repair
This is happening off and on, or I get system notice on dash-service 4WD or/and stability system service. What's going on? all fuses and bulbs good.
2004 Chevrolet Tahoe
-
Maintenance & Repair
how can I fix the problem
2001 Chevrolet Tahoe LS 4WD
-
Maintenance & Repair
2018 Chevrolet Tahoe
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.