GMC Suburban Questions Any type
- Recently Active
Obtained this vehicle in a "no start" condition. Attempting to fix problem. Engine turns over, will not start. Replaced the crankshaft position sensor. Now we have actual fire shooting out from top...
Will a complete disc brake rear axle assembly out of 1999 Silverado 1/2 ton truck fit a 1994 C1500 GMC Suburban
I have a 2004 GMC Yukon that we bought in October and it didn't come with a 3rd row. A friend of ours offered to give us his third row from his 2002 Escalade. Does anyone know if this would work?
send me a picture of a 5.7 motor so I can see the ERG valve
new fuel pump and fuel filter 6 months ago
replaced all wires plugs rotor cap fuel filter ..was loosing power under load /stalling at stop lite /hard to crank over .did run ok when cold but was hard to crank over/also need eng cyl #s and distr...
Aamco had found that when it warms up the timing advances 40 degrees and runs terrible...but even cold it does not want to stay running unless I keep my foot on the gas pedal.....just put the new ...
after reaching highway speeds for a few miles or approx 7mins. check eng. light comes on. The next time it is started up there is no light until I get on the freeway.
it gets no connection in the dash or ignition..
1995 suburban gmc 350 v8 told to use # 1 on left front of eng..then told to use #1 on rite side of engine for top dead center initial timing ....which one is correct ..can chevy be done either way?......
the stock replacement is a bad design with a pinch bolt holding the pitman arm on. I would like to get away from that but I don't know what other years will work
Favorite this topic
Subscribe to GMC Suburban questions.
Search GMC Suburban Questions
GMC Suburban Experts