All Car Questions
- Newest
- Recently Active
- Unanswered
My 01 Crown Victoria Check Engine Light Came On 4 Days Ago, When I Drive It...
now the car want start at all and the horn is almost dead
My 2004 Chevy Cavelier Will Go In Gear But When I Pull Out It Won't Change ...
My 2004 chevy cavelier will go in gear but when l put it in drive and pull out it won't change gears. It still runs good just won't change gears. The rpm gage will max out before it will change gears...
My 2002 Camry Does Not Pick Up Over 1 When Engine Running Put New Spark Plu...
my engine dont pick up i am going to try fuel filter put on dianostic code p1135 came up dont know what it mean plus i put in spark plugs 2002 camary 2.4 engine 150000 miles
What Would Cause The Mass Air Flow Sensor Constantly Put Out Low Input
Ok so just put in a brand new mass air flow sensor and it still coding out po102 which is low mass air flow current.what could it be? Dash lights stay on. Car idles erratically and doesnt go pass...
Rack And Pinion
My buick is making a clunk noise when i turn the steering wheel, (when the tires turn rotate at least 90 degrees, I have been told by mienieke that it is the rack and pinion. I have a buick lesabre. 2...
Rear Vision Is Blocked By The Two Rear Seat Headrests
The rear window vision is blocked by the 2 headrests and you lose half of the line of sight. Should the headrests be removed ?
How Do I Find Out Who The General Mgr. Is At Reliable Subaru In Springfield...
I had a bad experience with the sales dept. at the Subaru dealership in Springfield, MO. I would like to write a letter of my experience to the Gen. Mgr. and the Zone Mgr. Does anyone know how I find ...
Is A 2003 Dodge Transaxle Compatable With A 1997 Plymouth Grand Voyager Wit...
Tranny went out on my van. Found a 2003 but don't know if it will fit
Serpentine Belt Broke Outer Edges
replaced this belt in Jan. last time we heard something and found outer edges ripped off on fan
My Ignition Key Doesn't Work
it's almost impossible to turn it until it gets Just perfectly into the right position. One of them wont' turn at all. I think they are worn down too much Can i have a new one made without copying ...
| #1 |
|
tenspeed
Reputation
30,265
|
| #2 |
|
DavidH25
Reputation
28,955
|
| #3 |
|
Tom Demyan
Reputation
24,035
|
| #4 |
|
judge_roy
Reputation
19,165
|
| #5 |
|
littlehorn
Reputation
18,255
|