Checked all fuses, still can't figure why the windows don't work
Asked by Grandis_6241 Dec 28, 2014 at 11:50 AM about the 2005 Dodge Durango Limited 4WD
Question type: Maintenance & Repair
16 Answers
All the windows not working or is drivers side the only one that's working?
check the wires in the drivers door they are know for getting brittle and braking mainly the larger power and ground wires
sorry should have said the harness between the drivers door and the A pillar...you can see it with the door open it's in a rubber like boot ...you can actually just feel it and fell the broken wires in it sometimes
Grandis_6241 answered 9 years ago
Checked all wires seemed to be good shape nothing broke or loose either now the interior lights don't work I'm going to stick to painting
Will the engine start?
HAHA ..Ok ok lets go over this you say nothing on the master switch works at all? ....and you have both powers and grounds? the only thing it could be if you have them is the master switch ..the other windows get power though the fuse in the Power distribution center and the ground through the master switch via the lock out switch which shares the same ground with the dome light here are some wiring diagrams
here is the second one I will find out where the ground is for you
the ground is towards the center of the vehicle under the drivers seat ....you could try giving the ground circuit another ground via a jumper and seeing if the windows work ...its possible you have high resistance in the ground circuit and it shows good but isn't strong enough to handle the amperage
Grandis_6241 answered 9 years ago
Thanks John I'm looking into this again I'll get back to you tomorrow and again thanks
Just tap on the master window switch sometimes quite hard. That's how I found out it was the switch. Also always give the males a twist just to make sure the male is making contact within the female. The females are quite large in the Chrysler line up.
Sprint_10168 answered 7 years ago
I have a 2000 dodge durango and all of my windows stop working. Don't no Wichita fuse control the windows if that's the problem
This happened to me. All fuses good. Removed driver door inside panel. The wiring harness had become unplugged from the door controls. Reconnected and all windows now work.
06 durango, mirrors and locks work, just no windows. doesnt even make a hum or anything, just silence.
Only my driver side switch works rest are dead passenger side door locks work but no window cobtrols except driver
Same here cant figure it out
I wire was broken inside the rubber boot between the door and frame.. Move the entire bundle up and down while pressing controlling the windows.