I have a 2004 Sabaru Outback with the 3.0 engine, and on an extended drive it will start missing with an error code of P0303. I understand this means (misfire) is there an easy fix?

I have a 2004 Sabaru Outback with the 3.0 engine, and on an extended drive it will start missing with an error code of P0303. I understand this means (misfire) is there an easy fix? 1 Answer

i have a 2004 outback 3.0 that started overheating 3 days after i purchased it. I had the obveous replaced; heat sensor. radiater cap. When I went to rewplace the thermostate I found that it had been removed. Put in an after market therm and it didn;t change situation. I replaced water pump. That didn't work. Situation now is that the two upper hoses get hot quickly and are under pressure; lower hose is much cooler and not pressureized.Logic dictates either a bad therm (but it overheated even when the therm was removed) or a bad radiator (but the radiator seemed to pass water freely when I had it out. I understand there is a chemical that detects carbon in cooling system. Seems that should be my next step to rule out hg. I also understand that heater plays a roll in cooling system but not sure how much it would effect water temp and pressure. Any suggestions would be appreciated 2 Answers

started overheating. I replaced heat sensor, radiator cap. Went to replace therm. but found it didn't have one. Did relace it with a non subaru therm. Didn't solve problem so replaced water pump. A...

i have a 2009 forester with the 2.5 and i heard that a 2.5 out of a 2005 outback was a easy swap is this true 1 Answer

my 2009 forester is knocking and a very expensive used engine, i did a little research and heard that a 2.5 out of a 2005 outback is a direct swap is this true

I have an 05 Outback with a bad California emissions motor in it. I purchased a low mileage JDM Federal emissions engine to replace it with. Also 05 EGR .Do I have to switch the intake over ? 6 Answers

Do I have to switch the intake from my 05 California emissions engine onto my 05 JDM Federal emissions engine to get it to run correctly, when I install the new engine in my 05 Outback? Or can I mak...

HI MY outback Legacy H6 AWD auto has the VDC light on, and an engine symbol. I have tried to turn this off using the VDC switch but it does not work. Is this a big job? 1 Answer

I am trying to find somewhere close to sg11 Ware, Herts, that can repair my Subaru and get it through its MOT for a reasonable price.